OPT1-M-104 Rev.01 Optimus-1 EX - FTS Mast Assembly Procedure
Page 4of 33
Table of Figures
Figure 1 The FTS Mast Unit box, mounted on the upper mast .........................................................................8
Figure 2 FTS Main Antenna bracket mounting ................................................................................................. 10
Figure 3 Taoglass RF antennas bracket mounting ...........................................................................................11
Figure 4 Connecting the V-bracket sub-assemblies to the mast....................................................................12
Figure 5 The location of the FTS Mast Unit cabinet on the mast...................................................................13
Figure 6 Attach the hold hanging (metal pole clamp) brackets to the mast ................................................14
Figure 7 Attach the plate holders to the brackets and cabinet back .............................................................14
Figure 8 Open the lid of the FTS mast unit box..................................................................................................15
Figure 9 Open the lid of the RV50 cellular modem box ....................................................................................16
Figure 10 The SIM Card holder lid.........................................................................................................................16
Figure 11 The orientation of the SIM cards in the SIM Card holder ...............................................................17
Figure 12 The battery holder and its 4 screws ...................................................................................................18
Figure 13 The battery socket .................................................................................................................................19
Figure 14 The Power LEDs .....................................................................................................................................19
Figure 15 Antenna types .........................................................................................................................................21
Figure 16 Cable connections in the FTS mast unit back panel.......................................................................22
Figure 17 The FTS mast unit back panel.............................................................................................................22
Figure 18 The mast unit interfaces cover panel.................................................................................................23
Figure 19 The mast unit interfaces panel............................................................................................................23
Figure 20 The Mast main power switch ..............................................................................................................24
Figure 21 The LAN cable from MOXA Port 4 (POE) to the 2SP4 module......................................................25
Figure 22 The wire connecting the 2J4 connector to the 2F17 fuse .............................................................26
Figure 23 Electrical diagram of the Mast (V1 EX) DC electrical panel ...........................................................27
Figure 24 The location of the POE-162 Injector after installation...................................................................28
Figure 25 Mount the POE-162 Injector on the DIN mounting rail ...................................................................29
Figure 26 The POE+ Injector power input wiring panel terminators ..............................................................29
Figure 27 Connect the 48V+ wire via the 1A fuse 2F17................................................................................... 30
Figure 28 Connect the injector power into the POE+ unit ............................................................................... 30
Figure 29 Connect cables into the RJ45 interfaces ..........................................................................................31
Figure 30 The P1 and POE In-Use indicator LEDs .............................................................................................32
