Belluscura X-PLOR RES50051 User manual

Placing X-PLOR®in Backpack.
Backpack Instructions
PART 1
Disconnect the cannula and remove
the X-PLOR from the
small carrying bag, if applicable.
Pull on ring to open the front pocket, so
you can place the X-PLOR inside.
(Be sure that the LCD screen is facing up, the
cannula connector is located on the right side, and
the intake vent aligns with the mesh panel.)
Continue threading the cannula down
through the backpack, toward the X-PLOR.
(Pull the cannula out through the grommet so it can
connect to the X-PLOR.)
Place backpack on a flat
surface with the front pocket
and ring facing up.
Insert and thread the cannula
through the opening at the top
of the right shoulder strap.
Connect the cannula
to the X-PLOR.
Turn sheet over to continue to step 2.
1
3
5
2
4
6
By: XPLORoxygen.com

Wearing the BackPack.
Backpack Instructions
PART 2
Place backpack on shoulders
and adjust the shoulder straps so
the backpack is comfortable.
Roll the cannula tubing to the desired
length. Secure the excess tubing inside
the backpack with the Velcro straps,
making sure not to kink the tubing.
Wrap the cannula up and over
both ears and insert the nasal
prongs into your nostrils.
(The cannula should fit comfortably
around your head.)
Zip up the backpack and you’re
ready to go X-PLOR.
7
9
8
1 0
Store additional batteries inside the
backpack if desired.
LBL 5025-03 March 2022 ©2022 Belluscura LLC. All Rights Reserved.
By: XPLORoxygen.com