Bosstab Elite Evo User manual

www.bosstab.com
The Elite Evo
1
Lift base casing from the base
plate.
Installation Guide
If you are running your charging
cable through the surface,
ensure to drill a larger hole to
feed cable through.
Remove screws from case and lift
the case o the stand.
Press down the base casing over
the base plate.
Screw down your stand through
the base plate using the wood
screws provided.
4
1
5
2
6
3
Screw Mount (from above) instructions
We recommend drilling pilot
holes to assist with screw base
mounting.
Place case back on the stand and
screw back in the 4 screws.
Unlock case with keys provided
and remove faceplate.
Plug in your tablet while placing it
into the case and
place faceplate
back on and lock.
7 8 9

www.bosstab.com
The Elite Evo
2
Installation Guide
3
Screw Mount (from below) instructions
If you are running your charging
cable through the surface,
ensure to drill a larger hole to
feed cable through.
Screw down your stand through
mounting surface using the
screws and washers provided.
Turn case to desired rotation and
screw right hole for landscape
and left hole for portrait.
4 5 6
Unlock case with keys provided
and remove faceplate. Feed
charging cable through.
Using Allen key provided, tighten
screw at desired angle to lock in
position.
Plug in your tablet while placing it
into the case and
place faceplate
back on and lock.
Unscrew existing closed cable
cutout and install the open cable
cutout included with stand.
We recommend drilling pilot
holes to assist with screw base
mounting.
Unscrew the three screws to
remove the base plate and base
casing.
Optional Rotate Lock Optional Tilt Lock Optional Cable Through Channel
21