Washer to go
under screws
X3
M8 Security
Screws for
Rack mounting
X3
2. Mounting height of single or multiple adjacent racks E3VR-DYN
Cora Bike Rack - Australia’s Bike Parking Experts - WWW.CORA.COM.AU - PH 1800 249 878
Rack X1
(E3VR-DYN pre assembled)
Wall plugs
X3
For Multiple mounted racks
If multiple racks are
being mounted next to
each other, Rack height
must be alternated
NOTE: If all racks are to
be mounted at the same
height, racks must be
spaced at 600mm
centres
3. Drill mounting holes in wall 4. Insert wall plugs
Drill three (3) holes at
correct hole centres. Use
dimensions in image for hole
location
Drill holes 10mm diameter
and min 50mm depth to
accept wall plug for M8
screw
35mm
Assembly & Wall Mounting Instructions
Cora Bike Rack - E3VR-DYN
1. If mounting multiple racks, measure mounting distance between
racks and other obstructions and height from ground
To with AS2890.3
(2015) minimum 400mm
spacing between rack
centres to edge of walls
or other obstructions
comply
OR if no height alternation
of racks, minimum
600mm spacing between
rack centres and to edge
of walls or other
obstructions
min.400mm
spacing between
racks or from walls
For Single mounted rack
If mounting only one rack,
the rack should be fixed in
lower position to minimise
lifting for cyclist
Security screws
tool bit X1
Rev 1.00 March 2019 ©
