Craft33 TPOS15 User manual

Trash Pullout Installation Instructions
Installation Instuctions for TPOS15, TPOD18, AND TPOD21
REQUIRED TOOLS
•Drill
•Craft33 Wax Fill Stick
•Trash insert
•Plastic Receivers
•Double-sided Foam
Tape
•Jig #1, #2, and #3
•Magic Eraser®
•Glides
•Orange Receivers
•Screws
TRASH AND CABINET CONFIGURATION
Trash Pull Out Base Cabinet
TPOS15 (single trash) B15 or BFH15
TPOD18 (double trash) B18 or BFH18
TPOD21 (double trash) B21 or BFH21
STEP 1
8/18
•Using Jig #1, drill holes inside
back left and right corners
of cabinet.
This is where the plastic receiver
will be mounted for the glides.
SEE STEP 3.

STEP 2
•Install glides by sliding plastic
receiver into the back of
the cabinet.
•Reinforce by attaching glide to the
inner frame using screws provided.
STEP 3
• Remove glides from box.
• Install plastic receivers into back left
and right side of cabinet box where
holes were drilled in STEP 2.
Plastic Receiver

STEP 5
•Install orange receivers by
drilling them into the front left
and right corners on the base of
the trash pullout.
Orange Receivers
•Install unit into cabinet.
•Use Jig #1 or a level to verify
that the unit sits flush and evenly
with the frame.
Jig #1 (or a level)
QUESTIONS?
If you happen to have any questions or concerns during installation, please feel free to
reach out to a Craft33 Customer Care representative, and we will be happy to walk you
through the process.
Craft33
[phone]
craft33products.com
STEP 4