DAX DAX-8227 User manual

DAX-8227
BATHROOM FAUCETS SERIES

FEATURES
• Single Lever
• Ceramic cartridge
• Brass body
• Flow rate 1.5 GPM
• Installation hole 1-3/8”
• Chrome finish
• Hoses and mounting parts included
• Pop up drain not included (available)
DAX-8227
3-15/16”
1-3/8”
-3/4”Max
4-1/8”
G1/2
12º

ww w. daxib.c om
MODEL DAX-8227-CR
UPC APPROVED
ADA
NO
NO
ANSI APPROVED NO
ASME APPROVED NO
WATERSENSE CERTIFIED NO
NSF APPROVED NO
CONNECTION SIZE G3/8
FAUCET HOLE SIZE 1-5/16”
FAUCETS HOLE Single hole
FAUCET TYPE Basin Mixer
FLOW RATE (GPM) 1.5 GPM
HANDLE STYLE Single lever
NUMBER OF HANDLES 1
INSTALLATION TYPE Deck mounted
MATERIAL
FINISH
Brass body + zinc handle
Chrome
SPOUT SWIVEL
SPOUT TYPE
NO
Casting spout
CARTRIDGE TYPE Ceramic Mixer
POP-IP INCLUDED NO
MAX DECK THICKNESS 1-3/4” max
BATHROOM FAUCET DAX-8227
TECHNICAL SPECIFICATION DAX-8227

ww w. daxib.c om
INSTALLATION GUIDE DAX-8227
Faucet body
Basin counter
Threaded rod
Rubber washer
Locking washer
Hex coupling nut
Red braided hose Blue braided hose
Hex wrench
Lift rod
Lift handle
INSTALLATION STEPS
1. As shown in gure, connect braided hoses and threaded rod to faucet body tightly (Note: Position as red braided hose on
the left and blue braided hose on the right), slide lift handle into the slot at the back of faucet body, insert lift rod into the
hole at the bottom of faucet body and rmly connect with lift handle.
2. Pass faucet body through hole of basin counter, pad rubber washer and locking washer in turn, tighten with hex coupling nut.
3. Install drainage set and connect with lift rod.
4. Connect braided hoses with triangle valves. Note: Position as hot left and cold right.
5. Run water to check if the installation is qualied.

PART LIST
[email protected]
1
2
3
4
5
6
7
8
9
FH D38A-02
FH TJ-30504
FH D37-01C
FH DB-14
FH DB-13
FH 2123-28
FH TQ-07G
FH TQ41-02
Decoration cap
Internal Hex at end locking screw
Handle
Decorative ring
Locknut
Ø 1-3/8” cartridge
Washer
M24 aerator
Spout inner collar