Elfa CRSL606 User manual

Ceramic Cooktop Model : CRSL606
User Manual

Working Principle
The microcomputer ceramic cooktop directly employs
resistance wire heating, and realizes power regulation with the microcomputer
controlling different heating time and closing time of the resistance wire.
High temperature protection
The temperature sensor mounted on the radiant electric the temperature
inside the cooktop from timetotime.When an excessive temperature is
detected, the cooking plate will be directly disconnected and stop power
output.
Safety
Product Introduction
The microcomputer ceramic cooktop can meet different
kinds of cuisine demands because of resistance wire heating, micro-
computerized control and multi-power selection, really the optimal choice
for modern families.
The ceramic cookercooktopcenters on customers and adopts personalized
design.The cooktop hassafeandreliable performances,making yourlife
comfortable and enabling you to fully enjoy the pleasures from life.
2

3
Safety
Residual heat indicators
After using the cooktop,wasteheatremains in the heating area.The
power nixie tube shows the code “H”, warning to be away from the
heating area.
Auto shut down protection
During the cooktop working,it shut off automatically when the default
timing reach by the program if without operating. If several heating
zones work simultaneously,the cooktopwill be automatically shut off when
anyone heating area reaches it’s default timer. The default working
timer for various power levels are shown in the table below:
Installation
Selection of installation equipment
Drill holes on the table surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50 mm space shall
be preserved around the hole.
Be sure the thickness of the table surface is at least 30mm. Please select
heat-resistant table material to avoid larger deformation caused by the heat
radiation from the cooktop.
As shown in Figure (1)
Power level 1 2 3 4 5 6 7 8 9
Default working
time(hour) 8 8 8 4 4 4 2 2 2
50mm mini
50mm mini 50mm mini
50mm mini
560mm
490mm

Note: The safety distance between the ceramic cooktop and the
cupboard above the cooktop should be at least 760mm.
Air intake
Figure (2)
mini 50 mm
mini 20 mm
4
Under any circumstances,makesure the ceramic cooktop is well
ventilated and the air inlet and outlet are not blocked.
Ensure the ceramic cooktop is in good work state. As shown in
Figure (2)
Fix the hob on the table by screw four brackets on the bottom of cooktop
(see picture) after installation. Adjust the bracket position to suit for
different table top thickness.
screw
bracket
base
screw hole
mini 760 mm

5
Cautions
The ceramic cooktop shall not be mounted to cooling equipment,
dishwashers and rotary dryers.
The ceramiccooktop shallbeinstalled such that better heat radiation
can be ensured to enhance its reliability.
The wall and induced heating zone above the table surface shall
withstand heat.
To avoid any damage, the sandwich layer and adhesive must be
resistant to heat.
A steam cleaner is not to be used.
A board is must to be installed underneath the cooktop.
4.
5.
1.
2.
3.
6.
7.
If the cable is damaged or to be replaced, the operation must be
carried out by the after-sale agent with dedicated tools to avoid
any accidents.If the appliance is being connected directly to the
mains an omnipolar circuit-breaker must be installed with a
minimum opening of 3mm between contacts.The installer must
ensure that the correct electrical connection has been made and
that it is compliant with safety regulations.
The cable must not be bent or compressed.
The cable must be checked regularly and replaced by authorised
technicians only.
The socket shall be connected according to the relevant standard
or connected to a single-pole cut-out. The method of connection
is shown in Figure (3):
Figure (3)
Voltage&frequency
220-240V
50\60HZ
220-240V 2+2-N
50\60HZ
21
L
Black&Brown
1 2
L1 L2 Gray Blue N1 N2
3 4
43 5
5
Wire connection
NYellow/Green
Yellow/Green
Gray&Blue
Black Brown
Power line connection
The ceramic cooktop must be installed by a qualified, licensed electrician.
Please never conduct the operation by yourself.

The ceramic cooker hob appearance
Schematic diagram of the control panel
6
Power
regulating key
Childproof lock key
Power cord
ON/OFF
Glass plate
Control panel
ON/OFF
(1/4)

7
ON/OFF
Note: 1. If there is no any heat setting within 1 minute after
touching the “ON/OFF” symbol, the heating zone will
restore to the standby working mode.
2. Every heating zone is independent each other.
Child proof
Childproof lock: To ensure the safety of children, the
hob is provided with the function of childproof lock.
Activating the childproof lock: When the lock is
deactivated, touch the “childproof lock” symbol to activate
the childproof lock. However when in the locked position,
the " " touch control has priority and cuts off the
power to the hob. And the other buttons are disabled
except the “ ” touch control button and the “Lock”
button.
Deactivating the childproof lock: When the hob in the
locking mode, you can deactivate the childproof lock
by holding the “childproof lock” symbol.
The power of each heating zone are shown as follow:
Left rear Right rear
1200W 1800W 1800W
Left front
Right front
Heating zone
Power
Operation Instructions:
Touch the “ON/OFF” symbol for the corresponding heating
zone where there is a pot on it, and the corresponding
indicator displays “-". Then you can set the heat setting
by touching the “+” or “-“ symbol.
1200W
Instructions for Use
Preparation before using
After power on, a signal will sound, the four power indicator display tors light
up for 1 second then go out, indicating the ceramic cooker hob enters into
standby mode.
Put the pot in the center of the heating zone.

Never wash the induction
cooktop with water directlyto
avoid danger.
Keep electrical appliance out
of reach from children or
inform person. Do not let them
use the appliances without
supervision.
Safety Reminding and Maintenance
After being used for a long
time, the corresponding
heating zone of the ceramic
cooktop is till hot. Never
touch the ceramic surface to
avoid burning.
If the supply cord is damaged
, it must be replaced by the
manufacturer, its service agent
or similarly qualified persons
in order to avoid a hazard.
8
Never have the ceramic
cooktop to work without
food inside, otherwise its
operational performance may
be affected and danger may
happen.
Adedicated power protection
air swith protection air switch
must be incorporated in the
fixed wiring in accordance
with the wiring rules.
Never use the ceramiccooktop
in high temperature
environments such as near a
gas stove or kerosene stove.
For sealed foods such as
canned goods, please do not
heat them before opening their
covers so as to avoid any
dangers of explosion due to
heating expansion.
If the surface is cracked, swith
off the appliance to avoid the
possibility of electric shock.
Do not place rough or uneven
appliances, which may
damage the ceramic surface.
Do not put any detergents or
flammable materials in the
equipment installed under the
ceramic cooktop.
Do not leave metallic objects,
such as knives, forks, spoons
and lids on the hob as they may
get hot.

DISPOSAL: Do not dispose this
product as unsorted municipal
waste. Collection of such waste
separately for special treatment
is necessary.
9
Clean the ceramic cooktop
on a regular basis to prevent
foreign matters from entering
the fan thus influencing the
normal operation.
Light
Clean with hot water and
damp sponge
Cleaning sponge
Accumulation
of dirt
Clean with hot water and
abrasive sponge
Special cleaning
sponge for ceramic
glass
Rings and lime
crumbles
Sweetmeat,
melt aluminum
or plastics
Apply white vinegar to the
polluted zone, then wipe it
dry with soft cloth or a
special article available in
local markets
Use a scraper suitable for
ceramic glass (to protect
glass, a silicon product is
preferred) to remove
residuals
Special adhesive for
ceramic glass
Special adhesive for
ceramic glass
Cleanness and Maintenance
You can easily clean the surface of the ceramic cooktop if
following the methods given in the table.
Hint: please disconnect power before the cleaning.
Type of contam-
ination Method of cleaning Articles used for
cleaning
Indoor use only.