Equipment Defender PAS/Kombi Rack User manual

Equipment Defender
PAS/Kombi Rack
Assembly Instructions
EquipmentDefender.com
Patents Pending

Assembly Diagram
Use Hardware packet “ASSEMBLY HARDWARE”

Mounting The Rack On Open Trailers
Set the rack onto the trailer rail in the desired location and
mark the hole location, drill with a 27/64 drill bit.
Use Hardware packet:
“Open Trailer Mounting Hardware”
Mounting The Rack On Enclosed Trailers
(Enclosed trailer mounting brackets sold separately)
1. Screw the enclosed trailer brackets onto the
square tube using the self drilling/tapping
screws (included), leave approximately ½”
space as indicated.
2. Screw the rack onto the trailer wall. The
brackets are designed so the rack can be
mounted vertical or horizontal or any angle
in between. Note it may be necessary to
screw ¾“ plywood onto the wall if the
existing plywood is too thin.
Vertical mount
Horizontal mount
Mounted at 45 degrees
½” space
Mounting Holes

Bolts to trailer deck
Racks bolt on top
Bolts through top rail
Post can be cut to desired length,
but it must stick up above the rail
at least 4 inches
Open Trailer Mounting Post (sold separately)
This mounting post is a great option for trailers with weak top rails.
Round Rail Brackets (sold separately)
Bolts go through
the rack.
Rack bolts on top
Mark the hole that
is closest to the
center of the tube
and drill through
the tube with a
27/64 drill bit.
Drill through the
center of the tube

Each attachment requires a support side shaft bracket (sold separately.) Fig 1 shows proper setup of the shaft
bracket when used on a split shaft attachment, this method locks the attachment into the Equipment
Defender line trimmer rack and it also sets the attachment up to be used with the PAS/Kombi rack.
Using The Rack
Rack shown in
unlocked position
(Attachment can be
removed)
Rack Shown in locked
position
(Attachment can’t be
removed)
Set up the shaft bracket so the
attachment can’t be removed
from the trimmer rack
Shaft bracket is
used to lock the
attachment into the
rack
Fig 1

Changing the lock
Equipment Defender offers a commination lock (sold separately.)
1. Remove the screws that hold the two sides of the lock housing together. This will require a
tamper resistant tip hex wrench (included)
2. Remove the existing lock.
3. Install the new lock.
Note: If you wish to achieve maximum security bolt/screw heads can be filled with epoxy.
Combination Lock
(Sold Separately)
The combination can be
changed
1-1/2”
Cam
Instructions for setting your personal combination:
• The combination is factory set at >>0-0-0-0<<
• Combination must be on opening number prior to resetting
• On the underside outer edge of the lock there is a hole for the
code reset button. Rotate the face of cam until the code reset
button comes into view.
• Push this pin in with a paper clip and keep it pushed in
• Set your personal combination by turning the dials to the
desired combination – starting with the dial marked ‘1’, and
moving to ‘2’, ‘3’, and then ‘4’.
• Release the reset button and your combination is set.
• To lock, rotate lock to “locked” position. Rotate one or more
dials after lock is closed. To open the lock, turn dials to your
personal combination.