FRANZ VIEGENER Dominic Plus FV480/85.0 Instruction Manual

Provided
Allen wrench Handle fixation
wrench
Ruler Hacksaw
FV480/85.0
Handle
Escutcheon
Rough valve and
brass extension
(provided in FV480.BASE set)
Water flow in
direction of arrow
Connector
Installation Instructions
1- When installing valve to pipe connections make sure the valve is positioned with
the arrow pointing in the direction of the water flow.
CONGRATULATIONS !
This product has been subjected to stringent tests for its quality, performance and finish. We guarantee
years of trouble free operation. We thank you for your choice and above all for the trust you are placing
in us. This trust is what motivates us to improve every day.
Required instalation tools
Provided Not provided

Optional extension kit (not included) to use
when valve is installed deeper than normal.
Contact your dealer to purchase extension kit.
4 - Remove the brass extension.
3 - If the dimension exceeds the 1”
“maximum” distance, you must cut
the brass extension tube and valve
stem together as shown in the picture.
Brass extension
Wall
Limit
Max
Min
2 - Once the valve is in place, the wall
is closed and the tile installation is
completed, measure the valve
extension that is protruding through
the wall. Your finished dimension
should be between 7/8” to 1”.
If your finished dimension is correct,
continue to step 4.

7 - Turn the connector clockwise until
it stops. This is the “OFF” position.
6 - After the connector is in place, re-
mount the brass extension tube back
onto the valve.
5- Place the connector on the stem
and tighten with the provided allen
wrench as shown in the picture.

9 -Once the handle is placed and
the posicion had been checked, use
the provided wrench to adjust the
escutcheon.
Make sure the escutcheon matchs
paralelly with the handle.
Correct
Incorrect
8- Slide the escutcheon onto the
valve assembly. Slide the handle
assembly onto the valve with the
handle in the desired off position.
Hold the handle in place and tighten
the assembly as shown in picture 9.
10 - Make sure the lever position is
facing downward (6 o´clock position).

FV S.A. & FVA reserve the right to make revisions without notice in the design of faucets and bathroom accessories or in packaging.
FOFV480/85.0 / Edition No 1 _ March, 2014.
11- If you are unable to achieve
the proper position, remove the
handle and escutcheon from the
valve, loosen the allen screw on
the connector and remove it from
the valve stem. Reposition the
connector on the valve stem one
nocht to the right or left, as
needed to position your handle
correctly. Tighten the connector
and re-install the escutcheon and
handle assembly.