Furnika CARMA KRS05 User manual

COMPONENT PARTS
Name Tag Pcs
Picture
1
1
1
2
2
1
2
2
2
1
4
8
4
8
2
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
DISH RACK PARAMETERS
KRS05/1/3/600 535х460х160 (W×D×H)
KRS05/1/3/800 735х460х160 (W×D×H)
KRS05/1/3/900 835х460х160 (W×D×H)
O
M
MOUNTING
1
1.1 Attach the rack holder plate (D) to the dish rack (A)
1.2 Set the fasteners (C)
Edge strips (O)
unnecessary if the
thickness is 16 mm
D
B
45 224
82
2
2.1 Set the guide rails (B) and fix them with the self-tapping screws (L)
550
200 min
600 / 800 / 900
C
Dish rack
Set of right and left
guide rails
Set of right and left
fasteners
Front wall holder plate
Tray
Screw, M5×8
Half-round screw, M5×8
Screw, M4×4
Self-tapping screw, ST4×16
Self-tapping screw, ST4×14
Half-round self-tapping
screw, ST4×14
Edge strips
Set of right and left
edge strips
Tray holder plate
Rack holder plate
Master plate of front
wall holder plates P1
CARMA KRS05 assembly instructions
CARMA KRS05 – pullout dish rack with separators for dishware holding equipped with
the guide rails with the function of synchronization and dimensioning

3
4
D
3.1 Pull out the guide rails (B) and place the rack (A) on them
3.2 Set the tray (F) and edge strips (J)
FJ
4.1 Set the front wall holder plates (E).
It is possible to use the master plate
(P) for application of markings.
4.2 Attach the front wall to the rack (A)
and adjust it.
W
KRS05/1/3/600 507
Article
KRS05/1/3/800
KRS05/1/3/900
707
807
E
98
32
32
32
224
45
М5х13 angulare
adjustment
Tighten М5х15 after
adjustment
Up/down adjustment
Press the fasteners (C) on both sides of the rack (A)
to remove it
82
+/- 3o
M5x20
M5x13
M5x15
98*
W
32
32
32
* If the bottom thickness
is 16 mm
CARMA KRS05 assembly instructions
Adjustment conditions