11
•After selecting the desired target folder, save
the le(s) by selecting the Paste option in the
bottom-right corner of the display.
•Then the transfer window opens to show the
progress of the transfer.
•Successfully transferred data are listed under the
Succeeded tab.
•If the transfer is interrupted, the les affected are
listed under the Failed tab.
•
You are returned to the folder in which you
selected the pictures to be transferred.
Note – Transferring data
Since the procedure for transferring videos,
documents, etc. is identical, the corresponding
sections of these instructions refer to this
section.
Note – Transferring from and to the
same storage device
It is possible to transfer les from and to the
same storage device (for example, pictures and
videos from the Save2Data into a sub-folder).
7.1.3 Additional options in the context menu
•Photos
•By default, the pictures stored on the
Save2Data are displayed.
•Choose whether the pictures from the
Save2Data or your terminal device should
be shown.
•Select in the top-right corner of
the display
•
Use the circle at the left edge of the display to
select the picture(s) that you wish to transfer. On
successful selection, the circle turns red with a
white check mark
•To select all pictures at once, tap Select all at
the top-left corner of the display.
•Aside from the options to copy and move, the
context menu at the bottom edge of the display
also provides other options.
•Delete: Deletes the selected file(s) from the
storage location.
•Share: Opens the context menu of the
terminal device.
•More: The Rename option is displayed. This
option is only available for storage locations
on the Save2Data and with a single file
selected. Enter a new file name and confirm
with OK.
Note – Additional option
•The New folder and Rename options
are only available in the storage of the
Save2Data.
•Since the procedures for these additional
options are identical for videos, documents,
etc., the corresponding sections of these
instructions refer to this section.
