Let's Go Aero Tentris ArcRV SAR205 User manual

ArcRV™ Side Room Shelter
Model #SAR205

529cm, Saddle Poles, Fiberglass, shock-corded Tent Pole w/connector ferrules - green
623cm, Saddle Poles, Fiberglass, shock-corded Tent Pole w/connector ferrules, w/C-clips - green
682cm, Saddle Poles, Fiberglass, shock-corded Tent Pole w/connector ferrules - green
Saddle Pole Extensions
Saddle Pole Extensions with C-Clips
172cm, Spanner Poles, Yellow coded, Fiberglass, shock-corded Tent Pole w/C-clips-green
195cm, Spanner Poles, Blue coded, Fiberglass, shock-corded tent Pole w/C-clips-green
189cm, Spanner Poles, Red coded, Fiberglass, shock-corded Tent Pole w/C-clips-green
184cm, Base U-Tube Poles, Steel, chain-corded base Tent Pole - black
c
a
b
c1
d
e
f
g
SAR205 071615
c1
b1
b1

Rear Saddle Pole Extension

Install Rear Saddle Pole (c) without Extension Poles (c1)
IMPORTANT: The Extension Poles should be installed later for raising the structure,
thereby alleviating the need for a stepping stool for assembly. To insert Rear & Front Saddle
poles, stand on webbing strap, point U-Tube upward and insert.
Install the Front Saddle Pole (a)
Install the Upper Sides (e) and Upper Center (f) Saddle Poles
Assemble Center Saddle Pole (b) leaving the bottom sections unconnected (they are shock-corded).
Cord-lock the top of the Center Saddle Pole to the three Spanner Poles (e & f).
Pull Tent Cover over partially assembled frame (see Step 4 Cover Install section for details).
Install Rear Saddle Pole Extensions (c1), thereby lifting the Arc structure to full height.
Install Center Saddle Pole (b1) extensions (with clips) to U-Tubes (g).
Install the two Lower Spanner Poles (d) on sides and cord-lock them to Center Saddle Poles.
Saddle Pole Extensions (c1)
Rear Saddle Pole Extension Cord-lock Shown Below
c1
Saddle Pole Extensions with C-Clips (b1)

B) Attach Velcro wraps on cover to frame.
Wrap and clip the two sod flaps located on both sides of the ArcRV cover around the Steel
U-Tubes and tension the bungee cord locks on each end to engage the 360 Tension system.
A) Begin the ArcRV Main Cover installation by pulling the tail side of the cover center over the
center of the low side of the frame, and sliding the Cover up and over the tall side of the Frame.
Secure the four (4) corners of the tent at the lower corners of the Frame as shown in the attached
sketch. After getting each tent corner installed around the U-Tube corner, connect the cord ring
and the bungee hook (route the cord ring and the bungee hook around the Saddle Poles) at each
corner as shown.
ArcRV Add-Ons
A Stretch Connector is available to fully enclose the RV side of the Shelter and a Zippermate is available to allow
one or more ArcHaus shelters to be connected in series to the ArcRV.
• RV Connector Panel for stretch around doorways (Part No. SAR298)
• ZipperMate Extension (ZM18-106) for connecting multiple tents (Part No. SAR079)