Novus NDR-BA3104-II User manual

U s e r ’s m a n u a l
(short)
NDR-BA3104-II

NDR-BA3104-II
User’s manual ver.1.0
(Short)
All rights reserved © AAT Holding sp. z o.o.
2
EMC (2004/108/EC) and LVD (2006/95/EC ) Directives
CE Marking
Our products are manufactured to comply with requirements of following directives and national
regulations implementing the directives:
 Electromagnetic compatibility EMC 2004/108/EC.
 Low voltage LVD 2006/95/EC with further amendment. The Directive applies to electrical
equipment designed for use with a voltage rating of between 50VAC and 1000VAC as well
as 75VDC and 1500VDC.
WEEE Directive 2002/96/EC
Information on Disposal for Users of Waste Electrical and Electronic Equipment
This appliance is marked according to the European Directive on Waste Electrical and Electronic
Equipment (2002/96/EC) and further amendments. By ensuring this product is disposed of correctly,
you will help to prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or the documents accompanying the product, indicates that this appliance
may not be treated as household waste. It shall be handed over to the applicable collection point for the
waste electrical and electronic equipment for recycling purpose. For more information about recycling
of this product, please contact your local authorities, your household waste disposal service or the shop
where you purchased the product.
RoHS Directive 2002/95/EC
Concerning for human health protection and friendly environment, we assure that our products falling
under RoHS Directive regulations, regarding the restriction of the use of hazardous substances in
electrical and electronic equipment, were designed and manufactured in compliance with mentioned
regulation. Simultaneously, we claim that our products were tested and do not contain hazardous
substances exceeding limits which could have negative impact on human health or natural
environment.
Information
The device, as a part of professional CCTV system used for surveillance and control, is not designed
for self installation in households by individuals without technical knowledge.
The manufacturer is not responsible for defects and damages resulted from improper or inconsistent
with user’s manual installation of the device in the system.
IMPORTANT SAFEGUARDS AND WARNINGS

NDR-BA3104-II
User’s manual ver.1.0
(Short)
All rights reserved © AAT Holding sp. z o.o.
3
ATTENTION!
PRIOR TO UNDERTAKING ANY ACTION THAT IS NOT PROVISIONED FOR THE GIVEN
PRODUCT IN ITS USER’S MANUAL AND OTHER DOCUMENTS DELIVERED WITH THE
PRODUCT, OR THAT ARISES FROM THE NORMAL APPLICATION OF THE PRODUCT, ITS
MANUFACTURER MUST BE CONTACTED OR THE RESPONSIBILITY OF THE
MANUFACTURER FOR THE RESULTS OF SUCH AN ACTION SHELL BE EXCLUDED.
1. The installation of this device should be made by a qualified service person or a professional safety
system installer.
2. Device mustn’t be placed in places where ventilating holes are partially or fully covered.
3. User’s interference inside the device is not allowed and is unnecessary as it does not have any
systems which require adjusting or which are suitable for self-repair. You mustn’t dismantle the
recorder or remove any single fastening screws. If any repairs are necessary contact the service.
The device must be take care of and protected against any mechanical damage.
4. The device has to be protected against humidity and dust. In case the recorder had a contact with
water react immediately: switch off the power supply and contact the authorised Novus service. If
the device gets dirty it might get damaged or electrocute someone.
5. The device can only be cleaned with a damp cloth after the power supply has been switched off.
Avoid strong detergents (liquids and sprays). Mild detergents can be used if the recorder becomes
very dirty.
6. Power supply unit cords and signal cords should be laid in a way that eliminates the risk of
mechanical damage; special attention should be paid to the plug. Be careful not to overload sockets
and extension cords so that there is no fire.
7. To avoid devices’s damage vision and control signals should be equipped with systems protecting
against disturbances, over voltage and atmospheric discharge that are in compliance with Polish
regulations. It is also advised to use ground loop isolators.
8. The device mustn’t be used in conditions which do not fulfil operating requirements as far as power
supply, relative humidity or air temperature are concerned.
9. You cannot allow any metal objects get inside the recorder. It might cause serious damage. If a
metal object gets inside the device contact the authorised Novus service immediately.
10. The manufacturer does not bear responsibility for damage or loss of data stored on HDDs or other
media occurred during the usage of the product.
Attention!
Technical changes reserved without prior notice and printing errors possible.
IMPORTANT SAFEGUARDS AND WARNINGS

NDR-BA3104-II
User’s manual ver.1.0
(Short)
All rights reserved © AAT Holding sp. z o.o.
4
1. FOREWORD INFORMATION
1.1. Main characteristics
 Quadruplex: simultaneous recording, live monitoring, playback or backup and networking
 Linux-based operating system
 Real-time display
 1080p HDMI socket
 Recording speed up to 25 FPS per channel
 H.264 compression
 Recording resolution: 960x576, 720 x 576, 720 x 288, 360 x 288
 Advanced schedule recording & motion detection functions
 Audio recording
 Supports 1 SATA HDD
 S.M.A.R.T function
 Backup onto USB Flash Memory through USB port & via the network
 Backup as *.AVI files
 Advanced search of recorded images (by time or event)
 Networking (live monitoring, playback, archiving & alarm event e-mail notification, changing
DVR’s settings via the IE web browser)
 Dual stream; two independent network streams (SUBSTREAM and MASTERSTREAM) for
each channel
 Software: CMS application for remote administration, live monitoring and recorded data search,
NMS for live monitoring ,recorded data search and integration with NOVUS IP cameras.
 User friendly, multi-lingual graphical user interface
 Mobile platforms supported
 Mask function
 Event log
 Snapshot function exporting current frame to the .jpg file
 Supports settings import/export
 IP addresses filtering function
 PC mouse control (in-set included)
 12 VDC (100 ~ 240 VAC/12 VDC PSU in-set included)
FOREWORD INFORMATION

NDR-BA3104-II
User’s manual ver.1.0
(Short)
All rights reserved © AAT Holding sp. z o.o.
5
1.2. NDR-BA3104-II recorder technical data
FOREWORD INFORMATION
Model NDR-BA3104-II
Operation Mode Quadrupleks
Operating
System Linux
Video Input 4 x BNC
Video Output Main (split screen, full screen, sequence): 1 x BNC, 1 x VGA, 1 x HDMI
Audio Input 1
Audio output 1
Recording speed Up to 100 fps (960 x 576)
Compression H.264
Recording
Resolution 360 x 288, 720 x 288, 720 x 576, 960 x 576
Recording Mode Time-lapse, Motion detection, Schedule
Display Speed Up to 100 fps (real time)
Display Screen 1, 4, sequence, digital zoom of a selected screen area: 4x
Motion Detection 22 x 15 grid, with sensitivity defined individually for each channel
Video Loss
Detection Yes
Schedule
Recording Individual settings for: each day, each camera, possibility of combining individual recording modes
Recorded Data
Search By date/time, events (Motion detection)
Event History
Log Yes
Time
Synchronization Automatic time synchronization with NTP server
HDD Supports 1 HDD SATA
Backup HDD or USB Flash Memory through USB port, through the network
External Ports 1 x Ethernet - RJ-45 interface, 10/100 Mbit/s, 2 x USB 2.0 - for Flash Memory and PC mouse,
Control USB PC mouse (included) , IR remote control, Network
Menu Multi-lingual On Screen Display (OSD)
Software CMS, B-viewer (soon), Internet Explorer, Super Live Pro (iPhone, Android, BlackBerry),
Pocket Camera (Windows Mobile, Symbian)
User
Authorization Creation of user accounts with varying privileges, password protection
Power Supply 12 VDC (100~240 VAC/12 VDC PSU in-set included)
Power
Consumption max. 25 W with HDD
Operating
Temperature 0°C ~ 50°C
Relative
Humidity 10% ~ 90% (non-condensing)
Dimensions
(mm) 255 (W) x 50 (H) x 210 (D)
Weight 1 kg (without HDD)