Organized Living freedomRail Cubby GOBox User manual

Backing
Horizontal
(20)
(4)
(16)
Hanging
Brackets
Euroscrews
Connector Bolts
Left Side Right Side
Top and Bottom
Install (8) Connector Bolts into small holes on Top and Bottom Panels.
(a) Attach Top. (b) Lock Cams by turning clockwise until snug.
Step 4: Attach Top
Step 3: Attach Sides and Verticals
a
b
Lock
Cam
Open
a
a
b
Assembling the Cubby GOBox
Smaller Holes for
Connector Bolts
Top
Step 2: Install Connector Bolts
Vertical
Attach Hanging Brackets to Sides using Euroscrews. (If using Power Drill, set torque to low setting.)
Back Edge Back Edge
Right Side
Left Side
Step 1: Attach Hanging Brackets
(1)
Nameplate
and Screws
Vertical
Backing Nails
freedomRail Garage Assembly Instructions
Cubby GOBox
(a) Attach Sides and Verticals to Bottom. (b) Lock Cams by turning clockwise until snug.
Tools Required
Power Drill #2 Phillips
Screwdriver
#2 Phillips Driver Hammer
Contents of Package
Left Side Right Side
(16)
1
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Over
Top and Bottom

OrganizedLiving.com
1-800-669-3225
June 2015 ©2015 Organized Living
Bloomington, IN 47403
2
a
b
freedomRail Garage Assembly Instructions
Cubby GOBox
Step 7: Install onto Uprights
(a) Mount Cubby GOBox onto Uprights by inserting Hanging Brackets into the innermost track of each Upright. Two people recommended for
installation. (b) Mount Nameplate with Screws provided.
Insert the Horizontal section into the Cubby.
Step 5: Insert Horizontal
Install Backing with Nails provided into Top and Bottom Panels only.
Step 6: Install Backing