Outdoor Theater Systems Starter Series User manual

Starter Series
Instruction Booklet

1

Setting Up Your Screen
1. expand the frame, you will need two people. One person on each side of the frame
should grasp the 2 plastic joints on the edge in the center and walk backward pulling the
frame open Velcro side up.
2. With the screen flat on the ground, snap down each plastic joint into place.
3. Attach the black screen to the frame by aligning their Velcro edges together. Unfold
the screen in sections with two people, one on each side of the screen. Next, attach the
white stretch screen on top of the black. Pull tight to ensure a smooth viewing surface!
4. While the screen is flat on the ground, estimate about 5 feet out to the side from each
bottom corner. Insert 1 twist stake about 3 feet out from that point.
5. Hook each of the tie-down strap hooks into the D-Rings at the top corners of the screen.
6. With 2 people on each side, walk the screen up onto its base until it’s fully raised. Hook
the opposite ends of the tie down straps into the ground twist stakes. Pull the ends of the
tie down straps to tighten. Ta-Da! The screen is up!
4
2
Setting Up Your
Projection Tripod
1. About 8 feet in front of the
screen, open the tripod and
extend the legs. Twist on the media
tray. Adjust the height so the
projector will be centered with the
screen.
2. Place the projector and the
speakers on the tripod tray.
3. Plug in the USB cord headphone
jack from the speakers into the
projector.
4. Plug the power cord from the
projector into a nearby power
source. Power it up and connect a
media source! You’re ready to go!

7120 Shady Oak Road
Eden Prairie, MN 55344
952-513-7764
www.outdoortheatersystem.com
[e-mail]