Playnation COLOSSAL TAHOE User manual

COLOSSAL
TAHOE

STEP #1:
1. PLACE ONE 2 X 6 X 102 ½” SANDBOX BOARD FLUSH WITH
THE BOTTOM OF ONE 4 X 4 X 123” MIDDLE CORNER POST AND
ONE 4 X 4 X 123” REAR CORNER POST. LINE UP THE MIDDLE
CORNER POST WITH THE MIDDLE HOLES ON THE SANDBOX
BOARD AND THE REAR CORNER POST WITH THE HOLES 66 ½”
FROM THE MIDDLE HOLES ON THE SANDBOX BOARD. THE
SAND BOX BOARD SHOULD BE ON THE SIDE OF THE CORNER
POSTS WITH THE THROUGH HOLES. FASTEN THE SANDBOX
BOARD WITH 3 ½” LAG BOLTS AND 3/8” WASHERS.
2. REPEAT THIS STEP.

STEP #2:
1. ATTACH THE 4 X 4 X 126” LEFT TOP SIDE SUPPORT AND
RIGHT TOP SIDE SUPPORT TO THE CORNER POSTS AT THE
112” HOLE. FASTEN THE TOP SIDE SUPPORTS FROM THE
INSIDE WITH 6 ½” CARRIAGE BOLTS WITH ½” WASHERS
AND 3/8” WASHERS AND LOCKNUTS ON THE OUTSIDE.

STEP #3:
1. INSTALL 4 X 4 X 70” BLOCK SUPPORTS TO THE CORNER
POSTS AT THE 78” HOLES. FASTEN THE BLOCK SUPPORTS
FROM THE OUTSIDE WITH 6 ½” CARRIAGE BOLTS WITH ½”
WASHERS AND 3/8” WASHERS AND LOCKNUTS ON THE
INSIDE.

STEP #4:
1. PLACE 2 X 6 X 70” SAND BOX BOARDS FLUSH WITH THE
BOTTOM OF THE CORNER POSTS. FASTEN THE SANDBOX
BOARD WITH 3 ½” LAG BOLTS WITH 3/8” WASHERS.

STEP #5:
1. PLACE 4 X 4 X 70” DECK SUPPORTS ON TOP OF THE BLOCK
SUPPORTS. FASTEN THE DECK SUPPORTS TO THE CORNER
POSTS WITH 5” LAG BOLTS WITH 3/8” WASHERS.
2. FASTEN THE DECK SUPPORTS TO THE BLOCK SUPPORTS
WITH 5” LAG BOLTS WITH 3/8” WASHERS FROM
UNDERNEATH.

STEP #6:
1. PLACE THE 4 X 4 X 78” CENTER POSTS FLUSH WITH THE
BOTTOM OF THE BLOCK SUPPORTS, LINING UP THE PILOT
HOLES AT THE CENTER OF THE BLOCK SUPPORTS. FASTEN
THE CENTER POSTS TO THE BLOCK SUPPORTS FROM THE
OUTSIDE WITH 6 ½” CARRIAGE BOLTS WITH ½” WASHERS
AND 3/8” WASHERS WITH LOCKNUTS ON THE INSIDE.
2. FASTEN THE CENTER POSTS TO THE TOP SIDE SUPPORTS
WITH 5” LAG BOLTS AND 3/8” WASHERS.

STEP #7:
1. PLACE THE 4 X 4 X 62 ¾” TIRE SWING SUPPORT FLUSH ON
TOP OF THE BLOCK SUPPORTS, IN LINE WITH THE CENTER
POSTS. NO SCREWS ARE NEEDED FOR THE TIRE SWING
SUPPORT.

STEP #8:
1. PLACE THE 2 X 4 X 70” CENTER DECK SUPPORTS FLUSH
AGAINST THE CENTER POSTS, ON TOP OF THE BLOCK
SUPPORTS. MAKE SURE THE OFFSET HOLES ON ONE
CENTER DECK SUPPORT ARE UP AND THE OTHER OFFSET
HOLES ARE DOWN. FASTEN THE CENTER DECK SUPPORTS
TO THE CENTER POSTS AND TIRE SWING BEAM WITH FOUR
3 ½” LAG BOLTS WITH 3/8” WASHERS PER SIDE.

STEP #9:
1. PLACE THE 4 X 4 X 25” BLOCKS FLUSH ON TOP OF THE
BLOCK SUPPORTS, BETWEEN THE CENTER AND END DECK
SUPPORTS. FASTEN THE BLOCKS TO THE BLOCK SUPPORTS
WITH TWO 5” LAG BOLTS WITH 3/8” WASHERS PER BLOCK.

STEP #10:
1. PLACE ONE 5/4 X 16 7/8 X 69 ½” 3-BOARD DECK ON TOP OF
THE DECK SUPPORT ON EACH SIDE OF THE CENTER POSTS.
SECURE WITH 2 ½” WOOD SCREWS.
2. TO THE SIDE OF THE 3-BOARD DECK PLACE A 5/4 X 11 ¼ X
69 ½” 2-BOARD DECK. SECURE WITH 2 ½” WOOD SCREWS.

STEP #11:
1. PLACE THE 5/4 X 6 X 63” CENTER DECK BOARD ACROSS
THE TOP OF THE DECK SUPPORTS TO THE SIDE OF THE 3-
BOARD DECK.
2. PLACE A 3-BOARD DECK AND A 2-BOARD DECK TO THE
SIDE OF THE CENTER DECK BOARD, OPPOSITE THE
EXISTING DECKS.
3. MAKE SURE THE DECKS ARE EVENLY SPACED AND
CENTERED. SECURE WITH 2 ½” WOOD SCREWS.

STEP #12:
1. PLACE THE 4 X 6 X 77” CENTER POST SUPPORTS ON TOP OF
THE TOP SIDE SUPPORTS FLUSH TO THE CORNER POSTS.
WITH A 3/8” BIT DRILL THROUGH THE HOLES OF THE 4 X 6
INTO THE CORRESPONDING CORNER POSTS.
2. FASTEN THE CENTER POST SUPPORTS TO THE CORNER
POSTS FROM THE INSIDE WITH 6 ½” CARRIAGE BOLTS AND
½” WASHERS AND 3/8” WASHERS AND LOCKNUTS ON THE
OUTSIDE.
3. FASTEN THE TOP SIDE SUPPORTS TO THE CENTER POST
SUPPORTS FROM THE BOTTOM WITH 5” LAGS AND 3/8”
WASHERS.

STEP #13:
1. PLACE THE 4 X 6 X 39” END CENTER POST 28 ¾” FROM THE
CORNER POST. ATTACH TO THE DECK SUPPORT WITH A 5”
LAG BOLT AND 3/8” WASHER.
2. FASTEN THE END CENTER POSTS TO THE CENTER POST
SUPPORT WITH 5” LAG BOLTS AND 3/8” WASHERS.

STEP #14:
1. ATTACH THE 4 X 4 X 36” PORCH SUPPORTS TO THE MIDDLE
CORNER POST HOLES AT 55” WITH 6 ½” CARRIAGE BOLTS
WITH ½” WASHERS FROM THE OUTSIDE AND 3/8 WASHERS
AND NUTS ON THE INSIDE.

STEP #15:
1. ATTACH THE 4 X 4 X 123” PORCH CORNER POSTS TO THE
POCH SUPPORTS FROM THE OUTSIDE WITH 6 ½” CARRAIGE
BOLTS WITH ½” WASHERS AND 3/8” WASHERS AND NUTS
ON THE INSIDE.
2. ATTACH THE PORCH CORNER POST TO THE SIDE SANDBOX
BOARDS WITH TWO 3/8 X 3 ½” LAG BOLTS PER POST.

STEP #16:
1. PLACE THE 4 X 4 X 70” BLOCK SUPPORTS UNDER THE
PORCH SUPPORTS AND FLUSH TO THE CORNER POST.
2. ATTACH THE BLOCK SUPPORTS TO THE CORNER POST
WITH 3/8 X 5” LAG BOLTS AND 3/8” WASHERS.
3. ATTACH THE BLOCK SUPPOTS TO THE PORCH SUPPORTS
FROM UNDERNEATH WITH 3/8” X 5” LAG BOLTS AND 3/8”
WASHERS.

STEP #17:
1. ATTACH THE 2 X 6 X 70” SANDBOX BOARD TO THE PORCH
CORNER POST WITH TWO 3/8 X 3 ½” LAG BOLTS PER
CORNER POST.
2. ATTACH THE 4 X 6 X 42” PORCH CENTER POST TO THE
BLOCK SUPPORT FROM THE OUTSIDE WITH A 6 ½”
CARRAIGE BOLT AND ½” WASHER AND 3/8” WASHER AND
NUT ON THE INSIDE.

STEP #18:
1. ATTACH THE 4 X 6 X 70” CENTER CENTER POST TO THE
PORCH BLOCK SUPPORT FROM THE FORT SIDE WITH A 6 ½”
CARRAIGE BOLT AND ½” WASHER AND 3/8” WASHER AND
LOCKNUT ON THE PORCH SIDE.
2. ATTACH THE CENTER CENTER POST TO THE CENTER POST
SUPPORT WITH A 5” LAG AND 3/8” WASHER.
3. ATTACH THE 2 X 4 X 36” PORCH CENTER DECK SUPPORTS
TO THE CENTER CENTER POST AND THE PORCH CENTER
POST WITH TWO 3/8 X 3 ½” LAG BOLT EACH.
4 X 6 X 70”
CENTER
CENTER POST

STEP #19
1. PLACE THE 5/4 X 16 7/8 X 69 ½” 3-BOARD DECK AND THE
5/4 X 11 ¼ X 69 ½” 2-BOARD DECK ON TOP OF THE DECK
SUPPORTS.
2. SECURE THE DECK BOARDS WITH 2 ½” SCREWS.