
Installation instructions for bucket seats.
INSTALL INSTR. FOR TOPKICK and KODIAK
RAM Seat Bases
Item Number
RAM-VB-194 & RAM-VB-194-SW1 RAM Mounting Systems
RMR-INS-VB-194
RAM Mounting Systems
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
www.rammount.com
1. Move the passenger side seat to it’s most forward position.
2. Using a T-40 Torx bit, loosen but do not remove the two rear seat track bolts.
3. Move the passenger side seat to it’s most rearward position.
4. Using a T-40 torx bit, remove the two front seat track bolts on the passenger side seat.
5. Using a T-45, remove the bolt at the inside front of the seat frame box.
6. Gently tilt the seat back creating a gap between the seat frame box and seat track.
7. Place the No-Drill base at the front inside corner of the seat frame box.
8. Place the spacer washer over the mounting hole located on the door side where you removed the bolt.
9. Lower the seat back down and re-install / re-tighten all the seat mounting bolts. This includes the bolt
at the inside front of the seat frame box that requires the use of the T-45 torx bit.
Vehicle base for:
FORD TRANSIT FULL SIZE VAN (2014-2015)
STEP 8