Sherlotronics ELEGANT_TX User manual

Code-Hopping Encryption
Elegant modern design
3V Long Life Lithium battery
Frequency stability controlled +/- 75KHz
Order Codes:
This product is approved for use in Residential, commercial and Light Industrial
Environment and Complies with the essential protection requirements of the R&TTE
Directive 1999/EC on the approximation of the laws of the Member states relating to
electromagnetic compatibility and radio spectrum.
Certifications:
ETSI EN300 220-V2.4.1
ETSI EN301-489-3 V1.4.1
ETSI EN301-489-1 V1.9.2
IEC 60950-1:2005 + A1:200
ICASA TA-2018/1011
Elegant Wall Mount Transmitter
Approvals:
III
Models:
Encryption type:
Transmission frequency:
Transmission method:
Transmission range:
Voltage range:
Battery type:
Sleep mode current consumption:
Current consumption on TX:
Operating Temperature:
Dimension (lxbxh)
Gross weight
Release date:
ELEGANT_TX
Code hopping
403MHz / 433MHz
OOk
150m (Open air) 40m (indoors)
2.0V to 3.6 VDC
CR2032 Lithium
< = 1uA
< = 20mA
-7°C to 49°C
60 x 60 x 25mm
55g
July 2018
Technical Specifications:
Features:
Model No: ELEGANT_TX
Installation Instructions - For Service Persons Only
For more info visit our web site: www.sherlotronics.com
1 Ch Wall mount Transmitter (403MHz)
1 Ch Wall mount Transmitter (433MHz)
3V Lithium Battery CR2032
ELEGANT_TX
ELEGANT_TX_433
CR2032
English

1. Unscrew the base plate
2. Remove the battery carefully pushing it out the battery holder towards the middle of the PCB
3. Install a new battery Positive (+) facing upwards.
4. Test the unit is operating before closing the housing the units LED light should come on when pressed
Mount the unit in an upright position with the clip on the bottom. Avoid mounting on Metal surfaces and near High power cables. Not recommended to be
mounted in wet environments or outdoors. For indoor use only.
Please follow the relevant receivers installation instructions to correctly program the unit to a receiver.
The Elegant Transmitter is compatible to the following receiver models: Please check that the relevant frequencies match. We supply these products on two
different frequencies namely: 403Mhz or 433MHz
403MHz Part codes:-
Model: RX1-150; Model: RX2-150; Model: Rx3-150; Model: RX1-500; Model: RX4-500; Model: Mb4000
433MHz Part codes:-
Model: RX1-150_433; Model: RX2-150_433; Model: Rx3-150_433; Model: RX1-500_433; Model: RX4-500_433; Model: MB4000_433
CAUTION:
RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO
INSTRUCTIONS.
Location & Mounting
Replacing the Batteries
The unit is supplied with a CR2032 3V Lithium battery. The battery is rated at 240mA/h. The unit will be able to transmit over 10 000 times before the
battery is depleted. The unit will loose RF performance when the battery reaches below 2.6V DC. It is best to change the battery every 3 years if not
used very often for instance if it is used as a PANIC button. If the unit is used as a Door opener in a busy office environment then we would recommend
replacing the battery every year.
Programming a Receiver
Warranty
This product is sold subject to our standard warranty conditions and is warrantied against defects in workmanship
for a period of two years (batteries excluded)
Customer Support line: [phone] E-mail: [email protected]