StressVest SV-PSS Operator's manual
PAGE 1
STRESSVEST INC.
1080 Kingsbury Avenue • Winnipeg, MB, Canada R2P 1W5
Ph: (204) 336-0011 • Fax: (204) 586-2049
Sync Button
To Sync a StressVest SIRT RF, press SYNC BUTTON once and pull the trigger on the StressVest
SIRT RF. You should now hear a shot sound to indicate that they are now synced. Repeat this
process to sync additional StressVest SIRT RF’s.
To Unsync, hold down SYNC BUTTON for more than 10 seconds and release the button.The SYNC
LIGHT INDICATOR will flash and go out. All previously synced StressVest SIRT RF will now be
cleared including the keyfob.
IMPORTANT: When syncing (SYNC light is on), make sure that no other StressVest devices are
in sync mode (e.g. StressX Belt syncing to the CQT Instructor Tablet or StressX Belt syncing to
Transmitter). Also, be sure CQT Instructor Tablet is never placed in LIVE mode when Portable
Sound System is syncing.
Quick Operating Guide
Charging Port Key Fob Holder
Trigger Indicator Light
Activates on every trigger pull or
key fob activation.
Mode Indicator Light
Indicates that auxiliary sound
is muted.
Mute Toggle
Button
Mutes auxiliary
sound.
Auxiliary
Volume
Controls volume
from auxiliary
device.
Master
Volume
Controls volume
from SIRT RF’s or
Instructor Key Fob.
Auxiliary In
Connector for
auxiliary sound
cable.
Line Out
Connector for
external speaker
(optional).
Sync Light
Indicator
If no device is
detected, the light
will come on for a few
seconds, then flash a
few times and go out.
Fuse Holder
On/Off
Toggle Switch
SV-PSS
StressVest®SIRT RF (Sold Separately)
Note: Ensure you’re using StressVest®SIRT RF when
using the StressVest®Portable Sound System.
RF
PAGE 2
STRESSVEST INC.
1080 Kingsbury Avenue • Winnipeg, MB, Canada R2P 1W5
Ph: (204) 336-0011 • Fax: (204) 586-2049
POWER AND CHARGING
• Plug the charger into the charging port and then into the wall outlet.
• If the battery needs charging, both the green and red LED on the charger will light.
• Once the battery is fully charged, the red LED will turn off and only the green LED will be on. At this stage the charger will
provide a trickle maintenance charge to the battery.
NOTES:
• 16 hours is required for a full charge following a full discharge.
• The charger can be left connected during operation to maintain the battery for longer operating time.
• If the system is not used for a long periods, it should be charged every six months to maintain the life of the internal battery.
• If the sound becomes distorted or reduced in volume, this is a sign of a low battery. If the red LED on the power switch
begins to flash the battery has reached a critically low level and must be charged.
• It is recommended to charge the system before use to ensure maximum run time.
KEY FOB REMOTE ACTIVATOR AUXILIARY DEVICE
IED Bomb Sound FX
Mute (For Auxiliary Input Audio
Device)
Automatic Gun Fire
Sound FX
Auxiliary cable can be plugged into any MP3 playing device
that can accomodate the 3.5mm jack.
MP3 Device
(iPhone, iPod, MP3 Player, etc.)
3.5mm jack
StressVest® Portable
SIRT System
