611
HOW TO REMOVE THE FRAME GRILLE
②If you press within 1 second after no wired remote button press, then one second
after the control board buzzer to beep;
③If you press within 1 second after press the remote control button, press the
foregoing ①②③ continue.
3、Switch the operation mode
Press the M key, the unit can be switched on automatically, cooling,
dehumidification, ventilation, heating mode.
In addition, under cooling or heating, you can also set the sleep mode, the operation
is as follows:
In the cooling or heating down, if at the same time press the M key and key
was to enter sleep mode. At this point, if more simultaneously press the M key and
key, the corresponding cooling or heating mode to cancel sleep function.
4、Switching wind speed
Press the FAN button wired remote control, the unit can be switched between a high
wind speed, wind speed, wind speed and low wind speed automatic.
5、Set temperature
Press UP, DOWN keys, you can set the indoor temperature to be achieved.
Definable temperature range is 8 ℃ ~ 30 ℃.
6、Check、 Setting parameters
Press the M key on the wired controller (Mode button) for 10 seconds to enter the
parameter setting interface:
1)if has chosen to c display, LCD digital tube 1-2 shows "01", LCD digital tube 3-4
shows its setting default values, 26 ℃ icon and bright;
If selected as Fahrenheit, 3-4 LCD digital tube display parameters accordingly 01
set the default value of degrees Fahrenheit, and ℃ icon, not bright degree
Fahrenheit (could not bright) icon;
2）At this time
⑴If you press the POWER button, by the parameter setting interface back to the
main interface;
⑵If you continue to press the UP key, then LCD digital tube cycle parameters
02-03-04-05-01 1-4 and their setting default values (see previous table);
⑶If you continue to press the DOWN key, the LCD digital tube cycle parameters
05-04-03-02-01 1-4 and their setting default values (see previous table);
⑷If you press the mode key, then LCD digital tube 3-4 flashes 10 seconds, press
the UP button or DOWN keys, you can display the value of a corresponding
subtraction LCD digital tube during the 3-4, in which case:
WIRED CONTROLLER OPERATION
