x-HLAW
User Manual
Part Number:
Installation Instructions
Dual-Color LED Headlight Kit
Important: Read all instructions prior to installation.
Rev Date: V1 08/22/2018
Safety and Notes
• Product should be installed by a qualied technician.
• Ensure adequate ventilation—good heat dissipation prolongs product life.
• Power source must be 9–32 VDC.
• Ensure all wire connections are correctly made before applying power.
• If a fault occurs, contact Super Bright LEDs. Do not attempt to repair
product yourself.
• Beam pattern is only adjustable through vehicle’s existing aim adjustment
mechanisms.
• Images shown are for illustration purposes and may not directly represent
all models.
9003 (H4) and H13
The low beam is cool, white light. The high beam is warm, amber/
yellow light.
9006 (HB4) and H11
Switch lights ON/OFF to change color.
9003 (H4)
9006 (HB4), H11, and H13
Turn mounting ange
counterclockwise to release
bayonet-style connection and
remove ange.
Gently rotate light clockwise
until locked in place.
Insert light into housing.
Install mounting ange
into headlight housing.
Connect light to vehicle
wiring harness.
Rotate clockwise to lock
in place.
Line up and install light into
mounting ange.
Connect light to vehicle
wiring harness.
Color Selection
Begin by removing factory light. Due to dierence in physical size, existing rear dust cover will
need to be modied or discarded where applicable.
Note: Headlight images below may dier from actual part you receive. Wiring has been removed
in some instances for clarity, but does not detach from bulb assembly.
