THOMSON TM-SAU02W User manual

Soda Maker
Instruction Manual
Model: TM-SAU02W
Read this booklet thoroughly before using and save it for future reference
Recycle used batteries,
paper and plastic.
V1.0
801

1
Table of Contents
1. Disclaimer 1
2. Emergency Handling & Warnings 2
3. Safety Precautions 2
4. Feature Descriptions 4
5. Part Names 4
6. Installation 4
7. Instructions 5
8. Simple Troubleshooting 8
Disclaimer
Declaration:
This manual has been reviewed and proofread carefully; however, typographical and
technical errors may still remain. If there are mismatches to the actual machine due to
errors, please refer to the actual machine; such errors or omissions may not be used as
evidence in a court of law, and will be corrected with a new revision.
Our company reserves the right to change all contents in this manual at any time without
prior notice.

2
Emergency Handling & Warnings
Contact the customer service hotline of our company or a dealer nearby when
abnormalities occur.
Do not expose this machine to rain or humidity.
Safety Precautions
Soda Maker
Clean with a wet cloth; mild cleansers may be
used. Do not use any corrosive solvents; they will
cause the machine surface to erode.
Carbonating Bottle
1. Do not wash the plastic carbonating bottle in the
dishwasher or dry with a dish dryer; do not store
it in the freezer to prevent deformation.
2. Wash with clean water or mild cleansers. Do not
use hot water over 40°C.
3. Clean the plastic carbonating bottle regularly.
4. If the carbonating bottle is not needed after use,
leave the cover open to keep the bottle dry.
5. Storage temperature of the carbonating bottle is
between 1°C~40°C.
6. Cease usage immediately if bottle has
deformed, changed color or been damaged.
1. Check the Soda Maker and accessories (CO2 carbonator and plastic carbonating
bottle); contact your purchasing dealer immediately if damage or flaws are discovered.
2. Do not use the machine before flaws and damage are repaired.
3. Do not make any modifications or repairs to this product; repairs must only be
performed by us or authorized servicing staff.
4. Only genuine accessories must be used; failure to do so will void the warranty.
Dishwasher
Mild cleanser
Clean
Leave open to keep it
dry

3
Safety Precautions
Soda Maker Usage
This Soda Maker is specifically for making carbonated beverages. This device cannot
be used with other liquids or prepared beverages such as juices, beer or wine, etc.
Do not place the equipment near heat sources; avoid exposure to direct sunlight. Place
the machine on a flat and waterproof surface every time it is used; keep it in an upright
position during the operation process. Do not tilt the machine.
The CO2 carbonator must be removed during transport; do not rinse it directly with water.
Carbonating Bottle Usage
Cease usage immediately and replace with a new carbonating bottle when there are
anomalies such as scratches, damage or color changes, etc., or if its effective period of
use has expired.
CO2 Carbonator
Only genuine dedicated CO2 carbonators can be used with the Soda Maker to keep the
warranty valid.
Caution: The CO2 carbonator is pressurized; store it in a shady place (under 50°C). Avoid
exposure to direct sunlight or any heat sources.
1. Do not heat up the carbonator.
2. Do not place the carbonator in the refrigerator.
3. Do not touch the carbonator if its temperature is too low to avoid frostbite.
4. Keep the carbonator in an upright position; store in a shady place.
5. Do not remove the carbonator during the carbonating process.

4
Feature Descriptions
1. Food grade CO2 with purity up to 99.9%
2. Zero power consumption, safe, portable, DIY with no added
chemical ingredients.
3. Passed SGS food grade material certification.
4. Original connector with even bubbles.
5. Carbonator can be used repeatedly; healthy and
environmentally friendly.
6. Carbonating bottle is made with food grade PET materials; it
does not contain bisphenol A (able to withstand 12 bars of
pressure).
First of all, thank you for your support.
With the exclusive functions and designs of this Soda Maker system, you can turn flat water
into rich tasting carbonated water, or add any flavors that you prefer to create your own
carbonated beverage.
Part Names
CO2 Pressure
Release Button CO2
Carbonating
Button
CO2 Exhaust
Pipe
Carbon
ating
Bottle
Drip Tray
CO2
Carbonator
CO2
Carbonator
Fixture
Location
CO2
Carbonator
Protective
Case

5
Installation
1- Peel the
transparent film
on the CO2
carbonator off;
open the
protective
cover.
2- Push the rear
cover latch;
press
downwards to
remove the
rear cover.
3- Align the CO2
carbonator
with the body
of the
machine;
tighten the
threaded top
to fix it in
place.
*Confirm the
O-shaped ring
is around the
threaded top
before
installing the
CO2
carbonator; do
not install
carbonator if it
is not there.
Contact your
purchasing
dealer or call
our toll free
customer
service hotline.
4- Cover the rear
cover and start
using
immediately!

6
Instructions
1-Add water into the carbonating bottle; do not exceed the fill line.
2-Install the carbonating bottle onto the Soda Maker; rotate it
counterclockwise to fix it into place. Confirm that the carbonating bottle
is properly installed before carbonating. Caution, do not carbonate
under the following conditions:
1. Empty carbonating bottle, or not filled up to the fill line.
2. Carbonating bottle not installed in place.
3. Carbonating bottle not installed.
3-Press and hold down the carbonating button; press for approximately
0.5 seconds each time.
Caution: Do not press the carbonating button too hard or too long; this
will cause the water and bubbles to overflow and cause damage to the
machine.
4-Wait for 5-10 seconds until the CO2 and water has fully mixed; press
the pressure release button on the back to release the excessive
carbon dioxide.
5-Rotate the carbonating bottle clockwise to remove it; start enjoying
refreshing sparkling water. Different flavoring syrups can also be added
according to personal preferences.

7
Instructions
Reminder: To prevent damaging the carbonating bottle, adding flavoring syrup in another
container (glass bottle or cup) after making sparkling water is recommended. Use cold
water between 5-10°C to give it a better taste when drinking. Preparation of an extra CO2
carbonator for replacement at all times is recommended.
Replacing and Exchanging the CO2 Carbonator
If the sparkling water is not very bubbly or the water is not carbonated at all, the CO2
carbonator might be out of gas. Replace it with a same model of CO2 carbonator. Genuine
CO2 carbonators can be purchased from your dealer; please visit our website at:
www.wonder.tw for more information.
Caution: Do not replace the CO2 carbonator when the carbonating bottle is still on the
machine.
1. Remove the purple dust-proof cover of the new CO2 carbonator.
2. Remove the carbonating bottle from the machine before exchanging the CO2
carbonator.
3. Rotate the carbonator clockwise to remove it.
4. The empty carbonator can be refilled according to the refilling method of CO2
carbonators; replace the carbonator for the price for refilling.
5. Follow the instructions in the previous chapters, replace the CO2 carbonator by
using the instructions from the previous chapters to continue using the Soda
Maker.
Refilling the CO2 Carbonator
When the CO2 carbonator is depleted, call our toll free hotline [phone] or scan the
following QR-code.
Or visit our official website: www.wonder.tw to locate a service station nearby for refilling
and replacement.
Do not refill the CO2 carbonator by yourself; the carbon dioxide inside the CO2 carbonator
is food grade and complies with all quality and safety standard tests.

8
Simple Troubleshooting
Problem Possible Cause Solution
Water overflows when using
the machine.
The carbonating button was
pressed for too long.
The water was too full.
1. Press the pressure release button to release
excess CO2
2. The correct carbonating method is to press
the carbonating button for 0.5 seconds each
time for 2-3 times; fill the water up to the fill
line.
The carbonating bottle cannot
be removed after making
sparkling water.
Excessive CO2 in the bottle
was not fully released.
Press the pressure release button to release
excess CO2.
And the carbonating bottle can be removed.
The sparkling water has few
bubbles.
The CO2 carbonator might be
out of gas.
The carbonator temperature is
too low.
The water temperature is too
high.
Replace the CO2 carbonator using the
instructions previously described.
Leave the CO2 carbonator; wait until its
temperature has increased to room temperature.
Use drinking water with a lower temperature.