TRIOBIKE BOXTER User manual

SEAT ASSEMBLY INSTRUCTIONS
ENGLISH V 1.0
BOXTER

2 KIDS SEAT KIT PARTS
2x 3-points seat belts
4x DIN 912 M5x12 bolts
2x DIN 912 M6x14 bolts
Seat (with Velcro on the back side)
Backrest
2x L shaped brackets
3x Velcro strips
4x DIN 912 M4x8 bolts with integrated washer
TRIOBIKE
MODEL: XXX
COLOR: YYY

1- Hex key, sizes: 3, 5 mm
NEEDED TOOLS

1- Mount the brackets on the box, using 2xM4 bolt for each bracket, in the positions shown
above. ONLY FOR REAR SEAT: mount a bracket in the middle of the box rear wall, upside
down compared to the other brackets (use the bolts from the steering column).
REAR SEAT
FRONT SEAT
2- Connect seat belt shoulder holders to the rear wall on the box with 2xM5 bolt each in
the specific threaded holes.
ALL PICTURES SHOW 4 KIDS CONFIGURATION
67
ASSEMBLING THE SEAT

ASSEMBLING THE SEAT ASSEMBLING THE SEAT
9
3- Connect seat belt bottom parts to the box floor, using 1xM6 bolt each in the specific
threaded holes.
4- Remove the protectors from the Velcro strips on the backrest rear side.
5- Place the backrest on the box, as shown on picture. Apply some force so that the Velcro
adheres.
8

10 11
6- Detach the external layers of Velcro (the one protected by white film) from the back
side of the seat, and place them on top of the 2 side brackets. Apply some force so that the
Velcro strips adheres. Fold the exceeding part of Velcro under the brackets.
7- Place the seat on the brackets, aligned with the Velcro, and push so that the Velcro
adheres.
10
ASSEMBLING THE SEAT ASSEMBLING THE SEAT

TRIOBIKE A/S
Vesterbrogade 149, 1620 Copenhagen V - Denmark
phone: [phone]
[email protected] | www.triobike.com
TITLE