Bathroom TV Install Manual
Pre-Installation:
• Make sure that all parts in contents listing are present
• Setup the TV before installing to test all functions are working properly including the Wi-Fi and
Aerial connections.
• The wall chosen for install is level. Bathroom TVs use strong magnets to attach the TV to the
back-mounting plate. It is therefor essential the wall is flat.
• Decide on the positioning of your TV. We recommend as close to eye level as possible to
ensure maximum visibility. Avoid locations in direct sunlight, as this may cause screen glare
• Bathroom TVs must be recessed into the wall and must be sealed to the surrounding wall
using a bathroom silicone sealant.
Testing the TV prior to install:
1. Carefully lift the TV from the box, leaving the protective endcaps on the TV
2. One side at a time remove the foam endcaps, and remove the protective plastic bag
3. Remove the back-mounting box from the back of the TV. Be aware It’s secured with magnets,
4. Place the 2 endcaps on a firm surface and lay the TV face down on the protective endcaps to
protect the face of the TV.
5. Remove the inputs cover from the back of the TV.
6. Connect the WifiAntenna (supplied in the accessory bag)
7. Connect signal inputs (Aerial, HDMI etc.)
8. Connect the power supply
9. Turn on the screen using the power button on the remote, the standby light should flash
between red and green and the initial boot screen will appear.
10. Fit the battery (supplied) to the waterproof remote
11. Follow the instruction manual to test the functionality
12. After testing remove all the cables, but leave the antennae installed. Replace the inputs cover,
Refit the endcaps and place the TV in the original box until the back box has been installed.
