Acoustic B115C User manual

B115C and B410C
www.acousticamplification.com
OWNER’S MANUAL
Three Year Limited Warranty: Subject to the
limitations set forth below, Acoustic® hereby
represents and warrants that the components of
this product shall be free from defects in workmanship
and materials, including implied warranties of
merchantability or fitness for a particular purpose,
subject to normal use and service, for three (3) years to
the original owner from the date of purchase.
Retailer and manufacturer shall not be liable for damages
based upon inconvenience, loss of use of product, loss of
time, interrupted operation or commercial loss or any
other incidental or consequential damages including but
not limited to lost profits, downtime, goodwill, damage
to or replacement of equipment and property, and any
costs of recovering, reprogramming, or reproducing any
program or data stored in equipment that is used with
Acoustic® products. This guarantee gives you specific
legal rights. You may have other legal rights which vary
from state to state. Some states do not allow limitations
on how long an implied warranty lasts, so the above
limitation may not apply to you.
The information contained herein is correct at the time
of publication; yet, due to continuing improvement
and development, Acoustic® reserves the right to alter
specifications without prior notice.
Acoustic
P.O. Box 5111
Thousand Oaks, CA
91359-5111
All trademarks and registered trademarks mentioned herein are
recognized as the property of their respective holders.
1805 - 18311085
3
CALL
TOLL FREE
855-272-1090
OR VISIT OUR WEBSITE AT: acousticamplification.com
MISSING
damaged
parts?
assembly
questions?
B115C
B410C
350 WATT
1X15” BASS SPEAKER CABINET
400 WATT
4X10” BASS SPEAKER CABINET

1. Horn On/Off Switch: In the “down” position, this engages the piezo horn.
2. Combo Locking Speaker Connector Jack: Connects your amplifier head to the speaker
cabinet via locking connector or 1/4” speaker connector.
3. Parallel 1/4” Speaker Jacks:
a. These jacks can output to a second or third speaker cabinet in parallel mode* if the
Combo Locking Speaker Connector jack is used for your signal input.
b. If you’re not using the Combo Locking Speaker Connector jack, either of these jacks
can be used to input your amplified signal while the other jack can then be used as an
output to connect to a second speaker.
*Please note: when running in parallel mode the speakers combined ohm load should
not go below your amplifier head’s minimum ohm rating. For example, please refer to the
table below.
We do not recommend combining speaker cabinets with differing ohm ratings.
1 2 3
B115C and B410C
MODEL B410C
Power Handling (RMS) 400 Watts RMS
Speakers 4 X 10” custom ferrite drivers
Hi-Frequency Driver Piezo horn, switchable
Frequency Response 40Hz -16kHz
Max SPL 130dB (half-space measurement)
Inputs Dual 1/4” (parallel), Combo Locking Speaker Jack
Impedance 8 Ohms
Handles Retractable spring-loaded (side)
Caster Sockets Yes
Port Front Facing Shelf
Dimensions (LxWxH) 24” x 16.1” x 27”/61.1cm x 41cm x 68.5cm
Weight 64 lbs/29 kg
No. of Cabs & Ohm Rating Final Load presented to Amplifier
2 x 16 ohm cabs 8 ohms
2 x 8 ohm cabs 4 ohms
2 x 4 ohm cabs 2 ohms
MODEL B115C
Power Handling (RMS) 350 Watts RMS
Speakers 1 X 15” custom ferrite drivers
Hi-Frequency Driver Piezo horn, switchable
Frequency Response 35Hz -15kHz
Max SPL 130dB (half-space measurement)
Inputs Dual 1/4” (parallel), Combo Locking Speaker Jack
Impedance 8 Ohms
Handles Retractable spring-loaded (side)
Caster Sockets Yes
Port Rear Facing
Dimensions (LxWxH) 24” x 16.1” x 24.3”/61.1cm x 41cm x 59.6cm
Weight 55.4 lbs/25 kg