Admiral SNAKE User manual

Assembly instruction
Admiral SNAKE cable guide
Code:
Product:

Product:
Code:
SNAKES can have a base of
2, 3 and 4 meter.

1
3
5
?
6
7
2
A
number description article code
1 length gutter with connection set ZEKGSN110 & ZEKGSN110Z
2 length gutter ZEKGSN010 & ZEKGSN010Z
3 hinge set top and bottom ZEKGSN028 & ZEKGSN028Z
bend ZEKGSN100 & ZEKGSN100Z
6 brass bearing set short (per bag of 2 pieces)
7 brass bearing set long (per bag of 2 pieces)
8 SAM draadbeugel vangarm m beugel
Detail A
NOTE:
Use lenth profile always in the direction
of the arrow.
Keep the bended part to the base
of the arrow.
Code:
Product:
Assembly instructions Admiral Snake
( code ending with - Z- means black coated)
RECOGNIZE the parts

6
67
7 6
6
6
6
NOTE:
Long brass bearings only to be used
with connection elements.
Code:
Product:
RECOGNIZE the parts

NOTE:
Slots faces to "outside" and bottom.
Each build starts with the bottom hinge.
No matter the lenght of the base of the snake.
START
Product:
Code:
Building sequence:

wanted end product
STEP 1:
Connect hinge.
NOTE:
Insert short brass bearing from the inside out.
Use metal ring on the outside
insert rivit 4,8x8 mm
B
Detail B
Code:
Product:
Building sequence:

Connect the 2e length part.
NOTE:
Insert the LONG brass bearing from the inside out.
Connect the 3e length part.
NOTE:
Insert the LONG brass bearing from the inside out.
Product:
Code:
STEP 2:
Building sequence:
STEP 3:

Connect the bend.
NOTE:
Insert the short brass bearing from the inside out.
C
TOP
Detail C
NOTE:
Bends are inwards and on top.
Product:
Code:
Building sequence:
STEP 4:

D
STEP 6:
Connect all sub-assemblies to a SNAKE.
NOTE:
Slots faces to "outside" and ceiling.
Detail D
Product:
Code:
Building sequence:
STEP 5:
TIP:
put the current assembly asside. And start with the second sequence.
( assembly of all sub-assemblys is the last step.)
Connect all sub-assemblies acording drawing