AeroLEDs 01-1100 User manual

2010 AeroLEDs LLC 0010-0005 Rev: Initial Release Page 1
Manufactured by: Installation Guide:
AeroLEDs LLC Pulsar Lights
967 East Park Center Boulevard P/N 01-1100
Suite # 381 LED Navigation and
Boise, ID 83706-6700 Anti-Collision Light
Phone: [phone]
www.aeroleds.com
[email protected]
Exceeds 100 candela for position lights and 400 effective candela for strobe lights
Operating Instru tions:
Operational Voltage: 14 & 28 Volt Systems
Position Input Current: 0.4A at 14V, 0.2A at 28V
Strobe Average Current: 0.8A at 14V, 0.4A at 28V
Strobe Peak Current: 2.25A at 14V for 0.33 se onds
CONTINUED AIRWORTHINESS:
The Pulsar LED navi ation and anticollision
li ht assembly is desi ned with 4 forward navi ation LEDs, 2
rear position LEDs, and 18 LEDs mounted beneath the anti-
collision lens. Should any one LED fail, the unit must be
repaired or replaced. View LEDs with weldin o les for
eye safety.
INSTALLATION PROCEDURES:
1. The installation procedure described in the followin text is for a
sin le li ht installation, but the procedure is identical for multiple
li ht installations.
2. Print out the installation template (the pa e 3 of this document),
however be sure to set up the printer driver to NOT use Pa e
Scalin so the printer will replicate the template to the proper 1:1
scale, otherwise the template will be too small. The proper scalin
can be verified by placin the included ‘Y’ Mountin Bracket over
the printout to ensure a 1:1 fit.
3. By desi n, the ‘Y’ Mountin Bracket locks into the Pulsar product
body.
4. Print the template as described above and confirm a 1:1 scalin of
the printout.
5. Attach the template to the win tip (mountin ) position and mark
the screw and wire hole locations.
6. Mount the bracket usin three 6-32 100 de ree countersunk
screws. Ensure that the mounting bra ket is grounded to
stru ture via the mounting s rews. If necessary, route a round
strap from one mountin screw to structure round or terminate
the round shield from the shielded wire bundle to a mountin
screw. Proper chassis round is required for minimum RFI and for
protection from direct li htin effects.
7. Connect the red wire to switched power for the position li hts,
connect the yellow wire to switched power for the strobe li hts,
connect the black wire to the same chassis round as the
mountin screw, and connect the reen wire to the
synchronization wire from the other installed li ht(s). It is
recommended that the attached wirin dia ram be followed for
minimum RFI.
8. Attach the li ht to the mountin bracket and anchor in place with
the 8-32 hex head set screw (provided) that inserts into the rear
of the li ht.
9. Check all avionics systems for interference from this installation.
10. A fli ht check should be performed by a properly certified pilot.

2010 AeroLEDs LLC 0010-0005 Rev: Initial Release Page 2

2010 AeroLEDs LLC 0010-0005 Rev: Initial Release Page 3