AVARRO NX-TXL3790 User manual

Tilt X-Large TV Mount 37-90"/175lb
NX-TXL3790
P 1
V3

P 2
ENGLISH
1. Limited Warranty
a. General
Subject to the terms and conditions of this Limited Warranty, from the date of sale through the period of time for product
categories specified in Section 1(a), ADI warrants ADI branded products to be free from defects in materials and workman-
ship under normal use and service, normal wear and tear excepted. Except as required by law, this Limited Warranty is
only made to Buyer and may not be transferred to any third party.
ADI shall have no obligation under this Limited Warranty or otherwise if:
(i) The product is improperly installed, applied or maintained;
(ii) The product is installed outside of stated operating parameters, altered, or improperly services or repaired;
(iii) Damage is caused by outside natural occurrences, such as lightning, power surges, fire, floods, acts of nature, or the
like.
(iv) Defects resulting from unauthorized modification, misuse, vandalism, or other causes
unrelated to defective materials or workmanship, or failures related to batteries of any type used in connection with the
products sold hereunder.
ADI only warrants those products branded for ADI and sold by ADI. Any other products branded by third parties are
warranted by the third party manufacturer for a period as defined by the third party manufacturer, and ADI assigns to
Buyer those warranties and only those warranties extended by such third party manufacturers or vendors for non-ADI
branded products. ADI does not itself warrant any non-ADI branded product and sells only on an as is basis in accor-
dance with ADI’s terms and conditions of sale.
a. Specific Warranties for product categories are as follows :
Product Categories Warranty Period
Intrusion Wireless Communication Accessories 12 months
Keystones, Wall plates, Accessories 24 months
CCTV Power Supplies 24 months
In Ceiling Speakers 24 months
Magnetic Locks 24 months
Surge Protection 24 months
UPS (uninterruptible power supplies) 24 months
HDMI Distribution 24 months
6 Outlet Surge Protection 24 Months
Intrusion Audio Devices 30 months
Video Surveillance Monitors 30 months
Power and Relays 30 months
Hold-up Buttons 30 months
Video Surveillance Baluns 30 months
Smoke Detectors 36 months
DVR's, NVR's 60 Months excluding HDD; 36 Months
HDD (included in recorder)
HD Analog Cameras 60 Months
IP Cameras 60 Months
PIR’s 60 months
Analog Cables Limited Lifetime

P3
a. Specific Warranties for product categories are as follows :
B Connectors Limited Lifetime
Bus Terminals Limited Lifetime
Extension Cords Limited Lifetime
HDMI Cables Limited Lifetime
Jacks, Cords and Intrusion Communication Accessories Limited Lifetime
Patch Cables Limited Lifetime
Patch Panels & Brackets Limited Lifetime
Raceway Conduit Limited Lifetime
Wire Ties Limited Lifetime
Magnetic Contacts Limited Lifetime
Network Switches/PoE Switches Limited Lifetime
2. EXCLUSION OF WARRANTIES, LIMITATION OF LIABILITY
THERE ARE NO WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS
FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE
HEREOF. TO THE FULLEST EXTENT PERMITTED BY LAW, IN NO CASE SHALL ADI BE LIABLE TO ANYONE
FOR ANY (I) CONSEQUENTIAL, INCIDENTAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES ARISING OUT OF
OR RELATING IN ANY WAY TO THE PRODUCT AND.OR FOR BREACH OF THIS OR ANY OTHER WARRANTY
OR CONDITION, EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY WHATSOEVER, EVEN IF
THE LOSS OR DAMAGE IS CAUSED BY ADI’S OWN NEGLIGENCE OR FAULT AND EVEN IF ADI HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH LOSSES OR DAMAGES. Any product description (whether in writing or
made orally by ADI or ADI’s agents), specifications, samples, models, bulletin, drawings, diagrams, engineering
sheets, or similar materials used in connection with the Buyer’s order are for the sole purpose of identifying ADI’s
products and shall not be construed as an express warranty or condition. Any suggestions by ADI or ADI’s agents
regarding use, applications or suitability of the products shall not be construed as an express warranty or condition
unless confirmed to be such in writing by ADI. ADI does not represent that the products it sells may not be compro-
mised or circumvented; that the products will prevent any personal injury or property loss by burglary, robbery, fire or
otherwise, or that the products will in all cases provide adequate warning or protection. Buyer understands and will
cause its customer to understand that a properly installed and maintained product is not insurance or guarantee that
such will not cause or lead to personal injury or property loss. CONSEQUENTLY ADI SHALL HAVE NO LIABILITY
FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON ANY CLAIM AT ALL INCLUD-
ING A CLAIM THAT THE PRODUCT FAILED TO GIVE WARNING. However, if ADI is held liable whether directly or
indirectly for any loss or damage with respect to the products it sells, regardless of cause or origin, its maximum
liability shall not in any case exceed the purchase price of the product, which shall be fixed as liquidated damages and
not as a penalty and shall be the complete and exclusive remedy against ADI.
3. Limitation on Liability to Buyer’s Customers.
Buyer agrees to limit liability to its customers to the fullest extent permitted by law. Buyer acknowledges that ADI shall
only be deemed to give consumers of its products such statutory warranties as may be required by law and at no time
shall Buyer represent to its customers and/or users of ADI products that ADI provides any additional warranties. By
accepting the products, to the fullest extent permitted by law, Buyer assumes all liability for, and agrees to indemnity
and hold ADI harmless against and defend ADI from, any and all suits, claims, demands, causes of action and
judgments relating to damages, whether for personal injury or to personal property, suffered by any person, firm,
corporation or business association, including but not limited to, Buyer’s customers and/or users of the products
because of any failure of the products to detect and/or warn of the danger for which the goods were designed or any
other failure of the products whether or not such damages are caused or contributed to by the sold or joint concurring
negligence or fault of ADI.

P4
TOOLS NEEDED
Herramientas Necesarias
Outils Requis
SYMBOLS
Drill
Agujerear
Percer
Level
Nivel
Niveau
Caution
Precaución
Attention
Pencil Mark
Marque con lápiz
Marque de crayon
Screwdriver
Destornillador
Tournevis
Tighten
Ajustar
Serrer
Socket Wrench
Llave española
Clé ouverte
Heavy!
Tres Lourd
!Pesado
3/8”
10 mm
7/32”
5.5 mm
4. Returns
Subject to the terms and conditions listed below, during the applicable warranty period, ADI will replace Product or
provide a credit at purchase at its sole option free of charge any defective products returned prepaid. Any obligations of
ADI to replace Limited Lifetime warranty products pursuant to this warranty which result from defect are limited to the
availability of replacement product. ADI reserves the right to replace any such products with the then currently available
products, or provide a credit in its sole discretion. In the event Buyer has a problem with any ADI product, please call
your local ADI branch for return instructions:
For US call 1-800-233-6261
For Canada call 877-234-7378
For Puerto Rico call 787-793-8830
Be sure to have the model number and the nature of the problem available. In the event of replacement, the return
product will be credited to Buyer’s account and a new invoice issued for the replacement item. ADI reserves the right to
issue a credit only in lieu of replacement.
If any ADI branded products are found to be in good working order or such product’s inability to function properly is a
result of user damage or abuse, the product will be returned to Buyer in the same condition as received and Buyer shall
be responsible for any return freight changes.
5. Governing Law
The laws of State of New York apply to this Limited Warranty.
6. Miscellaneous
Where any term of this Limited Warranty is prohibited by such laws, it shall be null and void, but the remainder of the
Limited Warranty shall remain in full force and effect.

P5
A
B
C C
B
PRODUCT COMPONENT PARTS
TV Mounting Pattern (W x H)
Minimum: 100mm x 100mm
Maximum: 700mm x 450mm
HARDWARE PRODUCT NUMBERS
9
5mm
SPACER
X 4
13
12
X 4
LAG BOLT
STEEL WASHER
8
SQUARE
WASHER
X 4
4 5
12
M6 x 15
X 4
M8 x 15
X 4
M6 x 30
X 4
M8 x 30
X 4
36
M4 x 12
X 4
M4 x 30
X 4
STEEL
WASHER
X 8
11
10mm
SPACER
X 4
10
LAG BOLT
8mm x 65mm
X4
14
WALL
ANCHOR
X 4
M8 x 50
X 4
7
Contents
A 1 Wall Plate
B 2 Vertical Rails
C 2 Locking Mechanism
Contents
A 1 Wall Plate
B 2
C 2 Locking Mechanism
D2Pendant
D D

P6
STEP 1A - CONNECT VERTICAL RAILS TO TV
Connect Vertical Rails to TV
Conecte el adaptador al monitor
Connectez l'adaptateur au moniteur
STEP 1B - IF MORE CLEARANCE IS NEEDED
Connect Vertical Rails to TV
Conecte el adaptador al monitor
Connectez l'adaptateur au moniteur
or
or
1
2
3
X4
8
X4
8
109
OR
or
or
4
5
6
or
7
Spacers can be used when more clearance is required.
Spacers can be stacked 10mm + 5mm between TV and
vertical rails to allow for maximum of 15mm clearance.

P7
B
B
B
4~7
1~3
1~3
11
11
11
8
8
9 10
Diagrams show three possible options for using additional washers if hardware screws are too long to properly
tighten into the back of the TV.
! !
10 10
9
9
If necessary, select the proper spacer(s) as shown below
STEP 1- USE M8 STEEL WASHER IF THE PHILLIPS SCREWS FROM THE MONITOR KIT
ARE TOO LONG
A
OPTION
B
OPTION
C
OPTION

P8
STEP 2- WOOD STUD INSTALLATION (CONCRETE INSTALLATION SKIP TO STEP 3)
(2
1/3
”)
60mm
STEP 2A & 2B- LOCATE WOOD STUDS AND DRILL PILOT HOLES
Drill 4 pilot holes
Mark center of wood using stud finder and pencil,
use wall plate to level and mark pilot holes
Find stud and mark edge and center locations
Ubique el panel y marque las ubicaciones de los bordes y el centro
Repérez l'emplacement d'une poutre, puis marquez l'emplacement des bords et du centre de cette poutre
Drill pilot hole
Realice el agujero piloto
Percez le trou de guidage

P9
STEP 2C- MOUNT WALL PLATE TO WALL
X4
Mount wall plate
Coloque la placa de pared
Montez la plaque murale
12
13
12
13

P10
STEP 3 – SOLID CONCRETE INSTALLATION
Drill Pilot Hole
Solid Concrete
DRILL BIT
NOT INCLUDED
Level Drill Bit
STEP 3A & 3B- POSITION WALL PLATE, MARK, & DRILL PILOT HOLES
Drill 4 pilot holes
Position wall plate to desired location, level, and
mark pilot locations with pencil
Use wall plate to mark mounting locations/ drill pilot holes
Use la placa de pared para marcar el lugar donde se realizará la instalación
Utilisez la plaque murale pour marquer l'emplacement de montage

P11
STEP 3C- SOLID CONCRETE INSTALLATION
STEP 4A- ATTACH TV TO WALL PLATE & ADJUST TILT ANGLE
X4
Mount wall plate
Coloque la placa de pared
Montez la plaque murale
12
14
13
12
13
Hang vertical rails with TV attached
Cuelgue con el monitor adherido
Accrochez avec le moniteur installé
Pull spring lock
cord down and
gently push
bottom of panel
to wall and
release spring
lock. Panel is
now locked on
to wall plate.
Tilt
Rotate lever
clockwise
to hold
desired tilt
-3°~12°
Insert wall anchors gently into concrete wall
with hammer if necessary
Concrete Wall
Concrete Wall Hammer
14
Heavy, Assistance
Required
TRES LOURD ! Cette etape
requiert deux personnes
!PESADO! Necesitara ayuda
para realizar esta operacion

P12
STEP 4A- ATTACH TV TO WALL PLATE & ADJUST TILT ANGLE
Rotate lever clockwise to hold desired tilt
or
or
1/2”
D
Tilt
-3°~12°

STEP 4B- ADJUST THE SCREWS ON THE VERTICAILS TO LEVEL THE TV
Maximum leveling
adjustment 0.5”
P13

STEP 4C- ADDITIONAL SECURITY FEATURE (OPTIONAL)
TV
Wall
Plate
Vertical
Rails
Vertical rails have 7mm hole located at the
bottom for placement of pad lock for additional
theft) security (pad lock not included)
P14

P15
STEP 4D - ADJUST STRAP LENGTH (OPTIONAL)
Squeeze and
hold control
to adjust
cord length
Attach pendant to wall
plate with magnet.

CAUTION: DO NOT EXCEED MAXI-
MUM WEIGHT CAPACITY. SERIOUS
INJURY OR PROPERTY DAMAGE
MAY OCCUR!
Max Loading Weight: 175 lbs
PN: NX-TXL3790
NX-TXL3790
840049 30312 6
P16