beier 70 User manual

Beier Distribution e.K.
Bahnhofstrasse 151
D-96145 Sesslach
Tel: [phone]
Fax: [phone]
www.bogensport-beier.de
[e-mail]
- Seite 1 -
Then also insert the two 20 mm dowels into
the holes provided for the pre-assembled disk
stand.
Attention: The 10 mm dowels must be
aligned upwards.
Target stand
Item numbers 70, 413, 1596, 1597
Content
Screws:
1 piece target stand pre-assembled
2 pieces dowels 20 mm
2 pieces dowels 10 mm
1 piece screw M6 x 140 mm
2 pieces washers
1 piece wing nut
At the beginning, the two 10 mm dowels must be
inserted into the holes provided for the 20 mm dowels.

Beier Distribution e.K.
Bahnhofstrasse 151
D-96145 Sesslach
Tel: [phone]
Fax: [phone]
www.bogensport-beier.de
[e-mail]
- Seite 2 -
Now the target stand is finally
finished.
Now the target
stand is ready for
installation.
Slide a washer onto the screw, then
insert the screw through all three
woods. On the other side, slide a
washer again and turn a wing nut.
Finally, only the wooden legs have to be
unfolded and the wing nut tightened.