Biamp TTM-X-SM User manual

Secure Mount (TTM-X-SM)
Tabletop Installation
A) TTM-X Microphone
B) Alignment Pin
C) Alignment Hole
D) Secure Mount Stem
E) Mounting Screws (x4)
D) Secure Mount Nut
A: 9300 Gemini Drive, Beaverton, OR 97008 T: +1 877.242.6796 W: www.biamp.com
585.0010 AUGUST 2019

1. Cut a 5/8 inch (16 mm) hole through the tabletop where the microphone is to be located.
2. Place the Secure Mount stem onto the bottom of the microphone, align the alignment
hole with the alignment pin, and then attach with the included screws.
3. Run the microphone cable through the stem of the Secure Mount.
4. Feed the cable, then the stem through the hole in the table.
5. Slide the Secure Mount nut over the microphone cable and thread it onto the Secure
Mount stem from the underside of the table.
6. Attach the microphone connector into the RJ-45 socket on the under-table network box.
TABLETOP
TTM-X MICROPHONE
MICROPHONE CABLE
DRILL 5/8” (16 MM)
DIA. HOLE
SECURE MOUNT NUT
SECURE MOUNT STEM
INSTALLATION INSTRUCTIONS
NOTE: The Secure Mount is designed for use on a
table with a minimum thickness of 1/2” (13 mm) and
maximum thickness of 2” (51 mm).