Bison VB25FL User manual

1
—— Instruction Manual ——
VB25FL
Drill In Floor Anchor For Use In Floating Wooden Floors
Date: 8/9/18 Rev: 5B.A. N.J.C. File:\ I:\Publisher\Instructions\volleyball Ref#: 960971
Customer Service
[phone]
INSTALLATION OPTION USING EXPANDING CONCRETE ANCHORS
IMPORTANT NOTE:
1. Pilot drill a 7/8” diameter hole through floor structure. Then use a 7/8” carbide tipped drill to extend the hole at least 2 9/16” into
the concrete.
2. Open up hole in floor structure to 1 1/2” diameter, then route a hole 2 3/4” diameter by 3/8” deep at the top for the threaded
insert. Use caution so that the top of the insert is not below the floor level. If possible, route the hole at least 1/16” diameter

2
INSTALLATION OPTION USING GROUTED METHOD
IMPORTANT NOTE:
1. Bore 1 1/2” diameter hole through the floor and concrete using a carbide tipped drill bit to a depth of 6” maximum.
2. Route a 2 3/4” diameter by 3/8” deep at the top for the threaded insert. Use caution so that the top of the insert is not below the
floor level. If possible , route the hole at least 1/16” diameter oversize, to allow swelling and shrinkage of the wood flooring.
Filling any gap between the insert and the floor with silicone is recommended.
3. Remove anchor and turn bolt around as shown. Use the two nuts provided and lock bolt into the canister.
4. Insert into the hole and be sure the grout gets into the grooves outside of the canister.
5. Transfer screw hole locations (4) onto the floor and drill 1/8” diameter pilot holes, then tighten wood screws provided.

3
Volleyball Court Diagram
37'