BOERPLAY BPKE046.1G User manual

Rope bridge
BPKE046.1G
Powered by TCPDF (www.tcpdf.org) 1 / 1

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE BPK 046 1G A
Touwenbrug
Basic Play Kids
22-10-2019
Hoofdafmetingen Main dimensions
0,00 m
0,57 m
1,27 m
1,41 m
0,00 m
0,04 m
0,13 m
0,21 m
0,33 m
0,46 m
0,53 m
0,62 m
0,66 m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE BPK 046 1G A
Touwenbrug
Basic Play Kids
22-10-2019
Obstakelvrije zone Obstacle free zone
Obstakelvrije zone
Obstacle free zone
Opvangzone
Impact area
4,86 m
3,80 m
R1,50m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE BPK 046 1G A
Touwenbrug
Basic Play Kids
22-10-2019
Bodemplan Groundplan
Grondmarkering
Ground level marker
0,40 m
1,57 m 0,28 m 0,28 m 1,67 m
1,38 m0,48 m1,15 m0,48 m1,38 m
0,50 m
0,37 m
0,13m
o

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE BPK 046 1G A
Touwenbrug
Basic Play Kids
22-10-2019
Modules Modules
Opmerking
BenamingRev.Bew.
Volgnr
Progr.Type#
Nr
Basic Play KidsStaander 0,59m
G0 8BPKMOD41
Basic Play KidsHangbrug
G033BPKMOD12
Basic Play KidsInloopnet 0,59m
B
G041
BPK
MOD23
Basic Play KidsPaalkap 80x80
G053
BPK
MOD
44
Geleverde modules:
Zie tabel
Montageinstructie:
- De hoofdmaten geven de maten van de staanders en vloeren aan
- De detailtekeningen geven specifiek de maten van de verbindingen aan
- De modules met buizen zi n op de tekeningen bemaat op bovenkant kopplaat
- Overige modules zi n bemaat op de bovenkant (klimwanden, paalkappen, etc.)
Montagevolgorde:
1 - Graaf de gaten volgens het bodemplan
2 - Plaats vier keer 1+4
3 - Assembleer de overige modules met behulp van de moduletekeningen
4 - Plaats 2, verbind deze aan vier keer 1
5 - Plaats twee keer 3, verbind deze aan twee keer 1
6 - Plaats het typeplaat e op de aangegeven positie
7 - Controleer of het toestel voldoet aan de afmetingen zoals op blad 'afmetingen'
8 - Dicht de gaten en verdicht het zand
Controles:
1 - Correcte opbouw en alle bevestigingsmiddelen
2 - Controleer de afmetingen van de valbodem t.o.v. het toestel
Supplied modules:
See table
Assembly instruction:
- The main dimensions indicate the dimensions of the posts and floors
- The detailed dimensions show the specific dimensions of the connections
- The modules which contain tubes are dimensioned at the top of the flanges
- Other modules are dimensioned at the top (climbing walls, caps for the posts, etc.)
Assembly sequence:
1 - Dig the holes according to the ground plan
2 - Place four times 1+4
3 - Assemble the remaining modules using the module drawings
4 - Place 2, attach it to four times 1
5 - Place two times 3, attach them to two times 1
6 - Attach the identification plate to the designated spot
7 - Check that the equipment conforms to the dimensions shown on sheet 'dimensions'
8 - Close the holes and compact the sand
Checks:
1 - Correct assembly and all the fasteners
2 - Check the dimensions of the safety area with regard to the play equipment
Typeplaatje
Identification plate
B
4
2
1
3

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE BPK 046 1G A
Touwenbrug
Basic Play Kids
22-10-2019
Afmetingen Dimensions
0,00 m
0,05 m
0,50 m
0,62 m
1,38 m
1,41 m
0,00 m
0,05 m
1,30 m
1,41 m

LOGBOOK
Type indication Basic Play
Article number BPKE046.1G
Product Name Rope bridge
Maximum fall height 0,6 m
Construction year 2023
Certificate 142768
Inspection body Keurmerkinstituut
Groeneweg 2e, Zoetermeer
2718AA Zoetermeer
Manufacturer name Boer Speeltoestellen
Hyacintstraat 2 - 4255 HX Nieuwendijk
Phone: [phone]
Fax: [phone]
Installer name _______________________________________________________
_______________________________________________________
_______________________________________________________
Playground location _______________________________________________________
Information about the owner of the playground
Name: _______________________________________________________
Address: _______________________________________________________
Zipcode and city: _______________________________________________________
Contact: _______________________________________________________
Phone number: _______________________________________________________
Information about the manager of the playground
Name: _______________________________________________________
Address: _______________________________________________________
Zipcode and city: _______________________________________________________
Contact: _______________________________________________________
Phone number: _______________________________________________________
Powered by TCPDF (www.tcpdf.org)

LOGBOOK
Inspection and maintenance
Date of
inspection
maintenance
Time of
inspection
maintenance
Name
executor of
inspection
Name
executor of
maintenance
Found defects Parts to be
replaced
Accidents
Date
accident
Age of
victim Probable cause of injury Occurred injury Measures taken after accident

Inspection and maintenance intervals
Nr Inspection Maintenance
months
between
inspections
1
Verify equipment's stability, junctions and
missing parts Inspect bolts, screws and nuts for
absence, jams, corrosion and wear
Add missing parts, secure joints, apply
missing fixing agent and replace
corroded parts
1
2
Check suspension for wear Replace worn parts and/or remove non-
functioning parts
1
3
Inspect rotating parts such as hinges, rolling-
element bearings, etc for wear and acceptability
Replace worn parts and/or remove non-
functioning parts
1
4
Check wood for splinters, unacceptable damage
and signs of rot, especially at ground level
Repair damage Replace affected wood
Smoothen splintered wood and sharp
edges
1
5
Inspect foundation for stability, tearing and
coverage
Restore foundation and covering
material
3
6
Examine rubber and synthetic parts for wear,
damage and breakage Replace for OEM original parts
3
7
Examine fibre reinforced plastic parts, especially
slides, for wear
Replace for OEM parts if the fibres are
visible
6
8
Inspect metal for corrosion and damage in the
coating
Restore any damaged coating (after
removing rust and applying primer)
6
9
Check ropes, cables, chains and nets for wear
and damage Steel cables and nets which are
tensioned must be checked for tension
Replace parts where necessary Steel
cables and nets must be tensioned
3
10
Inspect equipment for unsafe changes and
additions
Remove unsafe additions and correct
unsafe changes
1
11
Inspect safety surfaces Restore and repair where necessary
1
Remarks
1 If used intensively, all points require extra attention
2 Extreme weather conditions and locations may require a higher inspection frequency Discuss this with the
supplier
3 Vandalism-sensitive locations require stricter inspections, possibly daily
4 Re-tighten all connections in Robinia equipment two months after first use
5 Re-span spatial networks two months after first use
6 Check the terrain regularly for items that do not belong there, are unsafe or may be used wrongly Examples
are poisonous plants, glass shards, etc Frequency depends on strain

7 Remember that bad maintenance leads to unsafe conditions and notably faster impoverishment of the
playground area
8 Replacement parts can be ordered at the manufacturer with the OEM part numbers on the module drawing
Drawings can be found in the user guide
9 The impact area shall be provided with impact attenuating surface according to the specified falling height
•Up to 0,6m height of fall: no requirements regarding impact attenuation
•Turf, topsoil: suitable up to 1000mm height of fall
•Loose fill (sand, gravel, bark, woodchips): up to 3000mm height of fall Layer thickness is height
of fall / 10 +100mm, with a minimum of 300mm
•Synthetic surfaces (Rubber tiles, artificial turf, wetpour, tigermulch etc ): height of fall and layer
thickness according to the information of the supplier
10 This list is conform the CEN-standard "playground equipment and surfacing NEN-EN 1176-7"
Improving the
foundations
(for equipment without concrete in the standard
foundation)
If the impact area is loose fill (sand, gravel, bark,
woodchip, etc ), or if the soil itself does not add to
stability of the equipment (i e sand, pumice, peat soil)
pour 50l of concrete per post
For instance:
Square: 0,6 x 0,6 x 0,16m
Round: ø0,35 x 0,5m
Round: ø0,50 x 0,2m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD BPK 068 G
Staander 0,59m
Basic Play Kids
17-10-2019
Samenstelling module Assembly module
Opmerking
BenamingRev.Bew.
Volgnr
Progr.Type#Nr
M10 - VZ 8.8
Bor moer
010010010BSV
4
1
M10x80
Slotbout
080010026BSV42
M10 VZSLUITRING 002010030BSV43
84395000014
interplay dop M10 wit
020011DOPKST44
Basic Play KidsStaander 0,59m vloer G008
BPK
OHO
15
Basic Play KidsGrondanker klein
372005
BPK
SME16
5
41 3
2
6
Grondmarkering
Ground level marker
400

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD BPK 033 G
Hangbrug
Basic Play Kids
4-3-2015
Samenstelling module Assembly module
Opmerking
BenamingRev.Bew.
Volgnr.
Progr.Type#
Nr.
5 x 50 - RVS A2-70
Schr ef Assy
050005002BSR32
1
M6 - RVS A2-70
B rgd pm er
012006011BSR122
Pin-T rx - RVS A2-70Veiligheids B ut 030006025BSR123
RVS M6SLUITRING 002006030BSR24
4
ZWARTROZETRING M5 000006RORKST325
Buis 42 en 42,4
Kettingklem
320077BBPSME126
Basic Play Kids
LiggerB916001BPKSME27
Basic Play KidsRailing v r klem
A
916002
BPK
SME28
Basic Play KidsHangbrug l pvlak
030001
BPK
SNT19
9
8
346 4 2 51
7

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD BPK 041 G B
Inloopnet 0,59m
Basic Play Kids
10-7-2018
Samenstelling module Assembly module
Opmerking
BenamingRev.Bew.
Volgnr.
Progr.Type#
Nr.
5 x 50 - RVS 2-70
Schroef ssy
050005002BSR161
M6 - RVS 2-70
Borgdopmoer
012006011BSR42
Pin-Torx - RVS 2-70
Veiligheids Bout
030006025BSR
4
3
RVS M6SLUITRING 002006030BSR8
4
M6 - VZ 8.8
Zeskantmoer
005006017BSV45
M6 x 50 - VZ 8.8Zeskantbout ISO 4014 050006021BSV
4
6
M6 - VZ 8.8
Sluitring
002006030BSV8
7
ZW RTROZETRING M5 000006RORKST168
Basic Play KidsGrondplaat netje
061029BPKOPE19
Buis 42 en 42,4
Kettingklem
320077BBPSME410
Basic Play KidsRailing voor klem 916002
BPK
SME2
11
Basic PlayInloopnet 0,59m
030002
BPK
SNT112
12
1
8
6
7
5
11
10
9
3
24

Opmerking
BenamingRev.Bew.
Volgnr.
Progr.Type#Nr.
5 x 50 - RVS A2-70
Schroef Assy
050005002BSR
11
Ral 5024Paalkap 80x80
A
524080
KAP
OM12
Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD BPK 053 G
Paalkap 80x80
Basic Play Kids
4-3-2015
Samenstelling module Assembly module
2
1
Powered by TCPDF (www.tcpdf.org)