BOSSCO BARRE PRO User manual

EXTENDED BOSS BARRE PRO ASSEMBLY INSTRUCTIONS
1.
On a clean surface that will not scratch the finish of the
bars, place two of the horizontal sections of one side of the
barre parallel to each other. Take the two specially made
Reinforcement pieces and place one each in-line of the
horizontal bars:
2.
Slide the Reinforcement pieces into the horizontal sections
until the ring-stoppers come into contact, as shown below:
3.
Line up the pre-assembled Center Support section
perpendicular to the horizontal pieces that now have the
Reinforcement pieces inside, with set screws facing up:
4.
Slide the pre-assembled Center Support over the horizontal
pieces until it lines up with the yellow markings:
5.
Slide the pre-assembled Center Support until the yellow
lines just disappear, and TIGHTEN LIGHTLY. Do NOT fully
tighten the set screws at this point:
6.
Slide other horizontal bars onto the Reinforcement pieces
and into the pre-assembled center support, until they come
to a stop against the ring-stoppers. Please note that the fit
is intentionally very tight. You may have to slightly “wiggle”
the horizontals to get them in place. LIGHTLY TIGHTEN set
screws. Do NOT fully tighten the set screws at this point:
PAGE 1 CONTINUED ON PAGE 2

7.
Align the pre-assembled barre end verticals with the now-
assembled horizontals, on each end of the barre (with set
screws facing up):
8.
After visually ensuring they are square, fully tighten the pre-
assembled barre end verticals on each side:
9.
Once the barre end verticals are square and tightened in
place, fully tighten the set screws on the pre-assembled
center support section, in preparation for picking up the
barre:
10.
Place the pre-assembled base stabilizers to the side of each
barre end vertical, making sure they are to the same side of
each vertical:
11.
With the help of an additional adult, lift the assembled
barre upper until it can be placed into the receiving
connectors on the base stabilizers:
12.
Place the assembled barre upper into the receiving
connectors on the base stabilizers. FULLY tighten all set
screws on the entire barre, once you have ensured that all
pieces are square:
ENJOY YOUR EXTENDED BOSS BARRE PRO!