Brainwavz 3M VHB Tape Installation instructions manual

INSTALLATION GUIDE
VHB TAPE & SCREWS
[e-mail]
In case of any problems please contact us by email:
3M™ VHB™ Tape Mounting Guide
For illustration only - your product may differ from one shown
Thoroughly clean and prepare surface
before installation(A). Mark the desired
location for your Brainwavz product (B).
When your product is in place and safely
hung, use the small sticky dots provided to
cover over the unused screw holes.
Peel the red backing off the
3M™ VHB™ tape.
Apply pressure by pushing the product (A) hard onto
the surface (B). This will help to develop high-strength
adhesion.
B
B
A
A
To ensure a more secure bond has been achieved, do not
use your new hanger for at least 24 hours after installation
or the hanger may fall down.
Bond strength at 20
Bond strength at 20
minutes is 50%, 24 hours is 90% and 72 hours is 100%
minutes is 50%, 24 hours is 90% and 72 hours is 100%.
Screws are highly recommended when mounting heavy or fragile items.
When mounting onto hollow/cavity surfaces we recommend using 3M™ VHB™
tape and screws for extra security.
Before screwing the product into place ensure your chosen surface is solid, dry and
secure.
Take care when removing 3M™ VHB™ tape from any surface as it may cause
damage.
Always use the screw caps provided - DO NOT over-tighten screws.
Safety Guidelines

Screws Mounting Guide
Recommended mounting surfaces
For illustration only - your hanger may differ from one shown
(A) Ceramic Tiles (B) Smooth Marble (C) Smooth Metal (D) Glass - Do not install on wallpapered, loose,
damp or wet surfaces.
(A) Brick walls (B) Wood (C) Concrete (D) wallpapered walls - Do not install on loose, crumbling
surfaces. If in doubt consult a professional for advice and installation.
Hold your product (A) on the wall (B) and
use a sharp pencil (C) to mark location of
the screw holes.
If included, install the washer/caps
If included, install the washer/caps
:
:
(Type A) All-in-one washer and flip-up cap.
(Type B) Two-piece metal washer and
twist-on cap.
Use a phillips/cross head screwdriver (A) to tighten the screw
until you feel resistance, do not over-tighten. If screw caps (B)
are provided, attach them now.
Carefully drill the holes into your wall, no
deeper than 30 mm.
3MTM VHBTM
TAPE
SCREW
MOUNT
Use a small hammer to gently tap the
supplied wall plugs into the hole.
34865062112A
B
B
C
A
A
A
B
A
B C D