Brother BE-1204C Use and care manual

1
Technical Reference
Title: Adjusting / Replacing rotary hook support bar
Date: May 27, 2008
Models: BE-1204C/BE-1206B
1. Make sure the machine power is turned off.
2. Remove the needle plate by removing the two screws
as indicated by the red arrows.
3. Using red T-handle (4mm) wrench, turn pulley in the
direction of the arrow to 200 degrees. Note: Cover has
been removed in the photo, but this is not necessary.
4. Remove the two screws as indicated by the red arrows
and remove the rotary hook support bar. The screw
head for the left screw is located underneath.
5. Install new rotary hook support bar but leave the
screws slightly loose.
Remove
Rotary Hook Support Bar

2
Technical Reference
6. Pull the needle down, by the thread guide above the
needle, until it locks into place. Align the tip of the
rotary hook bar behind the needle.
7. Position tip of rotary hook stopper so that a gap of
approximately 1 –1.5mm is maintained from rotary
hook bobbin basket as indicated by the red arrow and
tighten screws.
8. Turn pulley backwards, opposite of arrow, from 200 to
100 degrees (stop position).
9. Turn machine on and the needle will pop back up.
Remove
Loosen
Middle thread
guide
Remove
Remove
Rotary Hook Support Bar Tip