Buoyant WM1L1 User manual

                                           
1
BUOYANT
CABLE WINE STORAGE CONCEPT
www.buoyantwinestorage.com
FLIP THE WALL MOUNT
1
Flip the wall mount so that the small holes point
toward the ceiling, and large holes point
downward.
PLEASE NOTE: THIS POSITION OF THE WALL
MOUNT ONLY APPLIES WHEN INSTALLED AS A
BOTTOM WALL MOUNT.
SINGLE COLUMN LABEL
VIEW CONFIGURATION

2
Insert all 4 crimped cables through the small
holes on top of the bottom wall mount
bracket and pull them through the large holes
on the bottom.
INSERT CABLES INTO BOTTOM BRACKET
2
ASSEMBLE BOTTOM ANCHORS
3
Mount the male piece of the anchor(FM2) on
the cables along with the spring(FM3) and
FM4. Clamp FM5 unto cables using 2 hex
screws (FM6) so that they are all at the desired
height and all level.
ALLEN KEY REQUIRED:
HEX KEY: 1.5MM (0.059”INCHES)

3
SLIDE ANCHOR ASSEMBLY
4
Before you pull down your installer can draw a
level line on the wall to ensure that the wall
mount screwed into the wall leveled. Use the
appropriate screws, bolts and washers (4 sets)
to secure bottom bracket to wall.
SECURE BOTTOM BRACKET TO THE WALL
5
Slide the anchor assembly inside the large
holes of the bottom wall mount.
NOTE: Anchor assembly should only extend 2mm
below the bottom wall mount as shown below.

4
COMPLETED BOTTOM MOUNT ASSEMBLY
7
CUT CABLES
6
Cut cables below the bottom wall mount. Be
sure you do not cut the cable too short. NOTE:
Use cable cutter to cut cable.
Proceed to the main Installation Guide and
follow the POSITION EACH SHELF step.