C-TECH-I LI-VLV-4 User manual

C-TECH-I, INC USERS' GUIDE
3-Hole Lavatory Faucet
Applied Models: LI-VLV-4, LI-VLV-7
Thank you for selecting our products.
This Instruction contains the usage, manipulation, maintenance etc. To help
insure that the installation process will proceed smoothly, please read these
instructions carefully before you begin.
Notes:
zBefore installing the faucet, please read the instruction carefully.
zTo avoid the impact of poor water quality on the usage of the faucet, we
recommend that you install the aerator in water supply pipe which
manufactured by our company. Please refer to the local dealer for details.
zDo not disconnect the faucet body by yourself.
Tools and Materials:
zAssorted Screwdrivers
zAdjustable Wrench
zPipe Wrench
zWrench
zPliers
zThread Sealant
zOther tools as needed
1/5

C-TECH-I, INC USERS' GUIDE
Installation
See the illustration above
1. Position the faucet body (one for hot water and the other for cold water)at the
hole of the basin. As well as the spout at the middle hole
2. From the bottom, assemble the metal ring, gaskets, bolts and nuts (the
2/5

C-TECH-I, INC USERS' GUIDE
mounting kits in the figure). Tighten them with a wrench. Fix the spout and the
faucet body up to the basin appropriately.
3. Connect the cold and hot water connect hoses individually to the faucet body
and the spout.
4. Revolve one end of the cold and hot inlet hoses into the other connection of
the faucet body; and the other end connect to the cold and hot water supply.
Do not use excessive force
5. Connect the inlet hoses to the water supplies. Before connecting the inlet hose
to the indoor water supply pipe, you should pay attention to the three points as
follow:
1) Flush the pipe;
Max 860kpa(8.6bar)
Hot
Cold
2) There are no stings at the ends of the water supply pipe;
3) Using other seal materials at the ends of the inlet pipe is not allowed
Maintenance:
1. According to the water quality, periodically disconnect the aerator cover for
cleaning to avoid jam (See figure 1, figure 2 and figure 3). It will prevent the
leakages and cartridge damage if the spout jams;
2. The water supply pressure should be 140 and 860 kpa (Contain cold water
and hot water);
3/5

C-TECH-I, INC USERS' GUIDE
3. The faucet should be cleaned periodically to keep the surface bright.
Cleaning:
1. Flush with clean water and dry with soft cloth only;
2. Do not use any metallic scourers such as steel brush, hard cloth, polisher to
clean the faucet;
3. Do not use acid or alkalescent detergent to clean the faucet.
4/5

C-TECH-I, INC USERS' GUIDE
5/5