Place the Base (A) upside down on floor
and install the 4 Wheels (J) into the caster
holders on the base.
Place the 4 - 35” Uprights (B) on the
outside of each corner of the Base (A),
align with first set of holes and bolt into
place. Note: Do not fully tighten the bolts on Base Shelf (A).
Allows you to select the final angle of your shelving unit.
Align 22” Shelf (D) with second set of
holes on 35” Upright (B) and bolt into
place. Note: Do not fully tighten the bolts.
Align 20” Shelf (E) with third set of holes
on 35” Upright (B) and bolt into place.
Note: Do not fully tighten the bolts.
Insert the 4 - 28” Uprights (C) into the
top of the first 4 - 35” Uprights (B).
1. 2.
3. 4.
5. 6.
Align 18” Shelf (F) with first set of holes
on 28” Upright (C) and bolt into place.
Note: Do not fully tighten the bolts.