Champ 4022 User manual

Auto Body Toolmart
Champ Frame Straightening Equipment, Inc.
2545 Millennium Dr. Elgin, IL 60124 [phone]
www.autobodytoolmart.com
A6 - 7’ Glide Rails
B8 - Connector Brackets
C4 - Connector Bracket End Caps with
installed nuts & bolts
D10 - Rollers
E 10 - Hose Clamps
FNuts, Bolts, Washers
Parts List
4022 Paint Booth Hose Glide
Read all assembly instructions completely before attempting to assemble unit.
Improper assembly could result in damage to Light or injury to user.
WARNING
Frame Straightening Equipment Inc.
Made In USA
E
F
B
A
C
D

Connect Three Glide Rails using Connector
Brackets making sure that the bolt holes line
up on the Glide Rails & Connector Brackets.
Insert bolts to connect Rails & Brackets.
Tighten bolts securely
The connector bracket at the ends of the rails
will only need one bolt. The completed rail
should have three Glide Rails connected.
This will make a 21ft long Glide Rail. Repeat
this process for the other Glide Rail.
Hold the Glide Rail in place where it will be
installed. Mark the holes for the mounting
brackets. Drill or punch holes in your booth
wall and mount the Glide Rail using the
suppled nuts & bolts. Be sure to caulk
around the bolts to prevent unwanted air-
flow into booth.
Insert the Rollers into one end of the Hose
Glide.
Install Connector Bracket End Caps on end
of Glide Rails.
1. 2.
3. 4.
5. 6.

Use supplied hose clamps to clamp your
air hose to the Roller Hooks. (air hose not
included)
Tighten clamp to hold hose to hook. Be sure
not to overtighten and compress hose.
7. 8.
Your Hose Glide is now ready. Your air hose will need to be connected to your incoming air line.
The Hose Glide will keep your air hose off the paint booth floor out of the painters way. It will prevent
hose snags & tangles and increase hose life.