Cheviot 575 User manual

INSTALLATION INSTRUCTIONS
575 | Solid Brass Console Stand
What’s included in the box:
2 x Rod A –31”
1 x Rod B –22”
2 x Rod C –17”
2 x 4-way Connectors with Set Screws
2 x Console Feet
2 x Wall Mounting Brackets
2 x Console Feet Screws
4 x Wall Mounting Bracket Screws
4 x Drywall Anchors
1 x Allen Key
Notes:
1. Two people are required to install the console.
Installation:
1. Use a pipe cutter to cut the console rods to the desired lengths according to the
Cheviot Products sink you will be using in the table below.
Sink Model
Rod A
Rod B
Rod C
350/22 | ANTIQUE
31”*
18”
13”
350/28 | ANTIQUE
31”*
22”
14”
511/25 | MAYFAIR
31”*
20”
17”
553 | ESSEX
31”*
20”
15 ½”
1230/19 | NUOVELLA
31”*
16 ¾”
17”
1230/23 | NUOVELLA
31”*
20 ¼”
17”
1232 | NUO
31”*
16”
15”
1234 | NUO
31”*
19 ¾”
15”
*Rod A may be left at 31” or may be shortened according to the desired final height of
the console lavatory.
2. Assemble the console by threading Rod A through the 4-way connector. Repeat
for the opposite leg. Connect Rod B to the 4-way connectors on both ends. This
forms the horizontal bar across the front of the console. Connect Rod C to the
Wall Mounting Bracket on one end and to the remaining opening in the 4-way

connector on the other end. Repeat for the opposite leg. This will form the
horizontal bars on the sides of the sink leading to the wall. Mount the Console
Feet to the ends of Rod A that do not have plastic stoppers. Secure all
connections with the Set Screws and Allen Key provided.
3. One person should hold the sink being used in the desired position and at the
desired height.
4. A second person should slide the console stand under the positioned sink. If the
stand is too tall, adjust the height by cutting Rod A as necessary. Also confirm
that the horizontal support rods are at the desired height.
5. The second person should use a pencil to mark the screw positions on the wall at
the mounting brackets. They should also mark the center positions of the
console feet on the floor. The sink and console stand can then be moved away
from the wall.
6. Drill mounting holes in the wall and floor as marked. Insert provided Drywall
Anchors into the holes drilled in the wall.
7. Screw the Console Feet Screws into the holes drilled in the floor. Remove the
Console Feet from the assembled console stand and thread them onto the
Console Feet Screws.
8. Mount the console stand back onto the console feet and secure with the
provided Set Screws. The console stand should now be in installation position.
9. Secure the Wall Brackets to the wall using the screws provided.
10. Mount the sink to the wall according to the instructions provided with that
product.