Chipolino DOLCE SHEDL020 Series Instruction manual

This product complies with the requirements of Product Safety Directive
2001/95/EU and Toy Safety Directive 2009/48/EU of the European Parliament
and the European standard EN 12790:2009 “Child use and care articles -
Reclined cradles”, as well as all applicable for the toys of the arch European
standards and the Consumer protection law.
IMPORTANT! KEEP FOR FUTURE REFERENCE
INSTRUCTION MANUAL FOR USE OF
MUSICAL BABY BOUNCER
„DOLCE”

1
FOLLOW ALL WARNINGS, INSTRUCTIONS AND RECCOMENDATIONS IN
THIS MANUAL IN ORDER TO GUARANTEE THE SAFE USE OF THIS PRODUCT:
WARNING! NEVER LEAVE YOUR CHILD UNATTENDED !
WARNING! DO NOT USE THIS PRODUCT ONCE YOUR CHILD CAN SIT UNAIDED!
WARNING! THIS PRODUCT IS NOT INTENDED FOR PROLONGED PERIODS OF USE AND
SLEEPING.
WARNING! IT IS DANGEROUS TO USE THIS PRODUCT ON ELEVATED, SLOPED OR SOFT
SURFACES!
WARNING! ALWAYS USE THE SAFETY HARNESSES!
WARNING! NEVER USE THE TOY BAR TO CARRY THE PRODUCT!
WARNING! KEEPAWAY FROM FIRE!
Adult assembly is required!
To be used only for babies with maximum weight 9 kg and aged approximately up to 6 months.
This product does not replace a cot or a bed. Should your child need to sleep, place it in a suitable
cot or bed.
To be used for one child at a time!
Do not use this rocker if any components are broken or missing!
Do not use accessories or replacement parts other than those approved by the producer!
If unapproved parts were used, the manufacturer declines all responsibility for the product.
 Do not make any changes or modications to the product’s structure. Contact the dealer or an
authorized repair service for advice and/or repair.
Do not attach any strings or long cords to the product in order to avoid risk of suffocation!
Only use the product for the purpose that it was designed for!
Do not allow children under 3 years during the assembly in order to avoid access of the child to
small parts!
Keep away from children the plastic packaging in order to avoid the risk of suffocation!
Always secure the batteries compartment with its cover after placing the batteries.
Do not allow access of the children to the batteries and do not allow them to play with them!
Use only batteries of the recommended in this manual type and voltage.
Do not use batteries of different types.
Do not mix new and used batteries.
Follow the polarity shown in the batteries compartment.
Remove the damaged and depleted batteries.
Remove the batteries if the product will not be used for longer period.
 Donotthrowthebatteriesinopenre.Donotattempttoopenthebatteries.
IMPORTANT! The waste from the batteries must be discharged only in designated areas.
Do not throw out the batteries in the household trash! You can contribute to saving the
 environmentandprotectingpeople’shealthbyreducingthedangerouseffectofbattery
components by helping recycling.
IMPORTANT! WARNINGS AND INSTRUCTIONS FOR USING BATTERIES

2
PRODUCT FEATURES
Intended for use for babies aged from 0 up to approximately 6 months, who can not sit alone;
Intended for use for babies with maximum weight up to 9 kg;
3-point safety harness;
Arch with soft toys;
Music box with tunes, sounds of nature and vibrating function;
 Batteries,3pcs,typeАА1,5V(notincludedintheset).
123
45
67
8
910
DIAGRAM OF THE MAIN PARTS
Please check that the disassembled parts are avlaible in the package.
1 – Fabric cover
2 – Rear tube of the seat
3 – Legs – 2 pcs.
4 – Fixing element with nut – 2 pcs.
5 – Soft head support
6 – Rear support tube
7 – Music and vibration box
8 – Side base tube – 2 pcs
9 – Toy bar
10 – Front support tube

3
ASSEMBLY INSTRUCTIONS
FUNCTIOS
IMPORTANT!Followthoroughlytheinstructionsforuseandassemblystepsgivenintheguresin
this manual.
CAUTION! CHECK IF FIXING IS SECURE AFTER EACH ASSEMBLY STEP! Make sure all pins
show through the respective openings.
Tools needed to complete the assembly:ascrewdriver(notincludedintheset).
Theassemblystepsarenumberedfrom1to12.Usetheirdescriptionsbelowwiththegurecarrying
the same number.
1 – ASSEMBLY OF THE REAR TUBE OF THE SEAT TO THE SIDE BASE TUBES
Note:Pulloutthereartubeoftheseattomakesureitisxed
2 – ASSEMBLY OF THE LOWER END OF THE LEGS TO THE SIDE BASE TUBES
3 – ASSEMBLY OF THE UPPER END OF THE LEGS TO THE SIDE BASE TUBES
IMPORTANT!Eachlegisdesignedtottooneofthesidebases.Ifthefootdoesnottthebasewhen
mounting, you must remove it and mount it on the other base.
Performtheactionsshownintheguretomounttheotherleg.
4 – ASSEMBLY OF MUSIC AND VIBRATION BOX
5 – ASSEMBLY OF THE FRONT SUPPORT TUBE
5-1–InsertthetwoM5x50screwsintothelegopeningsandtighten.
5-2–Insertthetwoendsofthesupportintothecorrespondingholesonbothfeet.
6 – ASSEMBLY OF THE REAR SUPPORT TUBE
InsertthetwoM5x30screwsintotheholesofthesidebasesandtighten,andtheninserttherearsup-
portpipeasshowninthegure.
IMPORTANT!Thebacksupporttubeisdesignedtotonthesidebases.Ifthemountingdoesnottthe
base, you must turn it over and install it again.
7 – PLACING THE FABRIC COVER AND SOFT HEAD SUPPORT
Note: Secure with the fasteners of the upper pocket of the fabric.
8 – POSITIONS OF THE SEAT – UPRIGHT AND RECLINED
9 – ROCKING FUNCTION
Usetherockingfunction,whenthefrontsupporttubeisfoldedtotheseat(1).
Pulloutthefrontsupporttube,toxthebouncer(2).
Note:Makesurethebouncerisxedbypressingtheseatdownwards.
10 – SAFETY HARNESS
Fasten the two seat belts in the buckle.
IMPORTANT!Afteradjustingthelength,thebeltshouldbeastightaspossibletothechild’sbodywith-
out causing any inconvenience.
ATTENTION! The belt should not be twisted, worn out or torn.
11 – TOY BAR
12 – MUSIC AND VIBRATION BOX
Removethecoverofthebatterycompartmentwithascrewdriver.Insert3pcsbatteriestypeАА/1,5V
keeping the polarity. Secure the battery compartment with the cover.
When pressing the button of the music and vibration box, you will activate melody, sounds and vibration.

4
Rear tube of
the seat
Press
the pins
Side base
Music and
vibration box
Front support
tube Rear support tube
Connecting
elements Button Leg
M5x30 screw
M5x30 screw
M5x50 screw
X2
X2
X2
“click”
“click”
1
3
5 6
4
2

5
7
9
9
10 10
8
Upright position
Soft head
support
Fabric cover
Rotate
Batteries: 3 pcs type AA/1.5 V
ON/OFF Button
Button for vibration
Button for melodies
Button for natural
sounds
AA/1,5V +
–
safety
harness safety
harness
Holding pad
Front
support
tube
2
1
Reclined position
Press the
button
Press the
button

6
CARE AND MAINTENANCE
Clean the plastic and metal parts with damp cloth.
Clean all fabric parts and toys with damp cloth. Follow the washing labels.
Do not tumble dry or dry in drying machine!
Do not soak in water or other liquids the music/vibration box!
Do not use abrasive detergents or solvents. Do not bleach.
Always dry the product, allow it to dry before storing or reusing. Mold or rust may occur if you store
the products moist.
Do not place other objects on top of the bouncer as this may damage its structure, fabric parts or
music/vibration box.
Store the product in a clean and dry place. Do not expose the bouncer to direct sun light, rain,
moisture or sudden temperature changes!
Fabric composition:
100% polyester Soft toys: The toys are marked with
compliance sign
Materials used: textile, metal, plastic
SHEDL020xxx/29287/29288/29289