CNC Router Parts PRO4848 User manual

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
1
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
2
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Included Parts:

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
3
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Attach the CRP113-09 Machine Connection Bracket to the top of the 30” steel tubes as shown. Thread
the M16 Leveling Feet into the bottom of the tube.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
4
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Loosely attach the CRP113-07 Corner Brackets to the remaining tubes. Ensure the sides of the
brackets with 4 slots are vertical.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
5
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Attach the 20 inch tubes to the legs as shown. Repeat
this step for both sets of legs.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
6
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Ensure that the end of the crossmember tube is flush
with the side of the leg tube, and tighten the connections.
Repeat this step for all 4 brackets.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
7
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Use the remaining tubes to complete
the frame.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
8
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Again, ensure the tubes are flush and tighten the
remaining bracket screws.

CNC Router Parts
PRO4848 Leg Kit Assembly Instructions
9
Leg Kit Assembly Instructions
Version 2015Q3.1
Copyright©2015 CNC Router Parts LLC. All Rights Reserved.
Attach the socket heads and hex nuts
to the Machine Connection Bracket.
The axis extrusion of your machine will
be supported by the socket heads. The
remaining T-nuts and flat head screws
will be used to attach the extrusion.