Connex ProSight User guide

| Installation Quick Guide
1st Step: Mechanical Installation
1Mark mounting holes for camera, transmitter, and antenna
2Install the HD transmitter
3Attach camera and antenna
4Connect the HD receiver antennas and mounting case
Consider camera
cable length.
HD receiver can be
mounted on a tripod
Recommended to
position antennas
straight up
Snap the HD
receiver into the
mounting case
Optionally, fasten with
plastic ties
Camera can be
installed upside
down
Use the dampers to avoid Jello
effect. Secure dampers with pins
and locking clips
Mount the antenna
on the back of the
drone
Doc P/N: 9040962 | Rev 01 | Printed 06/17/16

2nd Step: Wiring and Operation
Doc P/N: 9040962 | Rev 01 | Printed 05/06/16
Copyright © 2016
Amimon LTD
, All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored
in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical or otherwise without prior written permission of
Amimon LTD.
Flight controller
Pairing of additional receiver/transmitter
5. Connect HD receiver
power and video
4.
Connect transmitter power
3.
Connect to flight controller CH1
1.Connect camera
2.
Connect antenna cables
Keep the camera cable
as far as possible from any high power cables and ESCs.
The delivered transmitter and receiver are already paired.
Connect the units with a USB cable and USB to USB OTG adapter. Paring is done automatically. Verify link LED is constantly ON.
6. Verify
communication
For best range and link
robustness, route the cable away from the antenna body.
2S - 4S battery,
7-17V
2S - 4S battery,
7-17V
Caution:
The antenna cable minimum bend radius is 5mm.
Flight controller
Pairing of additional receiver/transmitter
5. Connect HD receiver
power and video
4. Connect transmitter power
3. Connect to flight controller CH1
1.Connect camera
2. Connect antenna cables
Keep the camera cable
as far as possible from any high power cables and ESCs.
The delivered transmitter and receiver are already paired.
Connect the units with a USB cable and USB to USB OTG adapter. Paring is done automatically. Verify link LED is constantly ON.
6. Verify
communication
For best range and link
robustness, route the cable away from the antenna body.
2S - 4S batter y,
7-17V
2S - 4S batter y,
7-17V
Caution:
The antenna cable minimum bend radius is 5mm.
Flight controller
Pairing of additional receiver/transmitter
5. Connect HD receiver
power and video
4. Connect transmitter power
3. Connect to flight controller CH1
1.Connect camera
2. Connect antenna cables
Keep the camera cable
as far as possible from any high power cables and ESCs.
The delivered transmitter and receiver are already paired.
Connect the units with a USB cable and USB to USB OTG adapter. Paring is done automatically. Verify link LED is constantly ON.
6. Verify
communication
For best range and link
robustness, route the cable away from the antenna body.
2S - 4S battery,
7-17V
2S - 4S battery,
7-17V
Caution:
The antenna cable minimum bend radius is 5mm.