Costume Specialists Easter Bunny User manual

Wearing Instructions For
Easter Bunny
qThis costume is designed to be worn by someone of an average
build and approximately 5’5” to 5’9” tall.
qThe wearer ought to be of reasonable strength and stamina.
qT-shirt and shorts are best worn under the costume. It’s advisable
that the wearer drink plenty of liquids before and after the event.
qThe costume must be worn WITH shoes.
qBe sure to have a dress rehearsal. It takes two people about 10
to 15 minutes to put on the costume. Becoming comfortable in the
costume before the event will insure the best performance.
qHave Fun!!
This is
Easter Bunny
fully assembled.
If you have
any questions or
problems please call
Costume Specialists
at
1-800-596-9357
USA
M
a
d
e
i
n
t
h
e

Wearing Instructions For
Easter Bunny
This is
Easter Bunny’s
Parts List
Body
Shoe Bases
2 BSC Fans(located in
the Body)
Backpack w/
V-Mount Bag
2 Endura Baeries and
VL-2 Charger
ADDITIONAL ITEMS NOT
PICTURED:
• V-Mount(locatedin
BackpackBag)
• Y-Cable(locatedinBody)
• WaistSnapHoop
(locatedinBody)
• Setof3SupportStraps
(aachedtoWaistHoop)
• 1DustBags
• 2ShoeBags
• ChargerBag
• ShippingTrunk

4Reach into the Costume leg and
nd the elastic cuff.
Step foot into the cuff
so that the top elastic
sits at the knee, and
the bottom elastic is
secure at the ankle.
5Place the wearer’s foot into the Shoe
Base. Secure the
wearer’s shoe in the
sandal with the velcro.
1Check the Inventory. Make sure the
Batteries are fully
charged.
2Insert a fully charged Battery
onto the V-Mount
Plate. Secure the
Battery and zip the bag
closed, allowing the
Power Cord to hang
out of the bag.
3Put on the Backpack and
clip the belt. The
belt should rest
comfortably on the
hips.
Wearing Instructions For
Easter Bunny
6Attach the velcro on the Shoe Base to the
velcro on the Costume,
making sure to line up
the center front and the
center back. This should
be a snug t.

8Inside the Head there
is a velcro tab. Attach
the velcro on the Frame
Extension to the velcro
inside the Head.
Wearing Instructions For
Easter Bunny
11Plug the Power Cord on the
Backpack into the
Y-cable. The fans
should begin to run.
7Inside the Costume there are Three
Straps attached to the
Waist Hoop. Clip these
straps to the top of the
Backpack. Adjust the
straps at the top of the
Backpack to achieve
the appropriate height.
These straps hold the
weight of the Costume.
9While inserting the Frame Extension
into the head of the
Costume, pull the
Costume over the
Backpack and the
wearer.
10
Insert the Frame
Extension into
the pipes on the back
of the Backpack.
If the height of the
Costume is not
appropriate, insert the
Pins into the holes on
the pipes to achieve a
taller height.
12Zip and velcro the Costume
closed. Let the
Costume inate.
Ination takes approx-
imately 45 seconds.

Wearing Instructions For
Easter Bunny
Once the costume is inated, have the wearer check the visibility.
The best visibility can be achieved by adjusting the length of the Support
Straps.
If the viewing area is too low, shorten the Support Straps which will raise
the viewing area.
If the viewing is too high, lengthen the Support Straps which will drop the
viewing area.
The Frame Extension should be raised and lowered, with the adjustments
of the Suppport Straps, by moving the pegs up and down the Pipes.
BUT the weight of the Body should not be held by the Frame Extension.
13
Easter Bunny is now
ready to entertain!