Crystal Sound DCS-210 User manual
Instruction
DCS-210
THE TRANSMITTER
1. Synchronization
2. Mute
3. Microphone connector
4. Battery charge level indicator
5. Mute indicator/ built-in microphone
6. Charger connector
7. Built-in microphone
+372 880 13 74
+370 521 408 77
+371 665 55 007
+34 932 202 706
+7 925 235 47 05
+7 812 300 05 15 (techsupport)
+7 812 608 50 15 (head office Russia)
Tallinn
Vilnius
Riga
Barcelona
Moscow
Saint-Petersburg
1236 4 5
THE RECEIVER
1. Volume up
2. Volume down
3. Earphone connector
4. Battery charge level indicator
5. Signal strength indicator
6. Charger connector
During synchronization, one of the 775 channels is automatically
selected. To save battery, it is recommended to disconnect
equipment in the end of the tour
i
the_crystal_sound
thecrystalsound2014
thecrystalsound
123 76 4 5
radio equipment for excursions
To switch on the device, connect
the earphone / microphone to
the receiver / transmitter
Holding button
bring the transmitter
to the receiver
When Synchronization
is successful, the backlight
turns on
There is signal The connection was lost
To switch off the device,
remove earphone /
microphone
If there no signal from the transmitter for more
than 3 minutes, the receiver will be automatically
switched off
To switch on
Hold the button
for 1-2 seconds until red
LED is turned off
To switch off
Hold the button
for 1-2 seconds until red
LED is lit up
To switch on
Hold on buttons
at the same moment
for 3-5 sec until the green
LED is lit up
The transmitter is able to work without
connecting an external microphone
MICROPHONE
MUTE
SYNCHRONIZATION
Performed when the earphones / microphone are disconnected
THE SIGNAL
LEVEL
TO SWITCH ON /
SWITCH OFF BATTERY
CHARGE BUILT-IN
MICROPHONE
Connect the charge to the
device. When the device is
fully charged the green LED
will be lit up
To charge several devices
at the same time, use
special equipment
To be fully charged from 0 to 100% it will take 2.5 hours.
The operating time of the transmitter is 60 hours, the
receiver 100 hours
!✔
To switch off
Hold on buttons
at the same moment
for 3-5 sec until the green
LED is turned off
