InstallingComponentsintotheCSS Page9
Installing a Module
You may install any of the following modules into the CSS: sensor interface
module, Protected Junction Box, Alarm Output Module (AOM), or Interface
Cable Adapter Module. You may mount the AOM on the door of the CSS
(because the AOM does not require grounding). All other modules should be
mounted in the shelter’s main box. To install the AOM in the cover, attach the
double-stick pads to the base of the AOM and use the double-stick pads to
secure the AOM to the door of the shelter in the location shown below. To
mount a module in the shelter’s main box, use the #4 x 1/2” (12.5 mm) self-tap-
ping screws as shown below.
I
NSTALLING
A
M
ODULE
When grounding modules installed in the shelter’s main box, use the ground
jumpers supplied with the CSS to connect the terminals inside the “module” to
the ground lug as shown below Use a #10-32 screw, #10 washer, #10 split lock
washer, and #10 hex nut to secure the ground jumper to the ground lug.
G
ROUNDING
M
ODULES
(I
NDUSTRIAL
SIM S
HOWN
HAS
2 G
ROUND
J
UMPERS
)
