Dean Mean16 User manual

Owners Manual
Amplifier Specifications
For warranty information
and claims contact
Dean Musical Instruments
15251 Roosevelt Blvd.
Suite 206
Clearwater,FL 33760
Phone [phone]
Fax [phone]
www.deanguitars.com
Specifications and information in this
manual are subject to change without notice.
Designed in Germany - Made in Korea
C E
Input Impedance . . . . . . . . . . . . . . . . ˜1MΩ
Bass Control. . . . . . . . . . . . . . . . . . . . . 120Hz +/- 15dB
Mid Control . . . . . . . . . . . . . . . . . . . . . 800Hz +/- 13dB
Treble Control . . . . . . . . . . . . . . . . . . . 4kHz +/- 18dB
Shift Control (Overdrive) . . . . . . . . . . 1,3kHz˜4,5kHz spectrum shifter
Output Power Rating . . . . . . . . . . . . . 16Watt RMS into 8Ω
Ext. Speaker . . . . . . . . . . . . . . . . . . . . . Min. 4Ωload, 16 Watts
Speaker. . . . . . . . . . . . . . . . . . . . . . . . . 8Ω, 8” (22cm) / 30 Watts max.
Max. Power Consumption. . . . . . . . . 25Watts
Caution
1 - Before using the Dean Mean 16 read this Owners Manual throughly.
2 - Do not open the unit! No user serviceable parts inside.
3 - Refer servicing to qualified service personnel.
4 - This amplifier is capable of producing high sound pressure levels.
Continued exposure to high sound pressure levels can cause permanent hearing
impairment or loss. Ear protection is recommended if this amplifier is operated
at high volume.
5 - Do not use in dusty, wet or extremely hot environments.
6 - Contact qualified service personnel immediately if:
♦The housing is damaged and the unit does not work properly
♦Small items or liquids of any kind penetrate the unit
♦In the event of any other problem
7 - 5 Year Warranty

Control Knob Functions
1
1
2
3
45678910
11
12
HI - INPUT
Connect your guitar either to the
HI orLOinput.UsetheHIinputfor
passiveguitarsto achieve bestgain.
2LO - INPUT
The LO input is best for active
guitars (built-in preamp).
3VOLUME (Clean)
Select the desired volume for your
CLEAN sound. This only effects
your volume when the select
switch is left in the out position.
4SELECT (Switch)
Switch between CLEAN and
OVERDRIVE sound. When the
SELECT switch is pressed, the
overdrive channel is engaged.
5DRIVE CONTROL
Controls the level of distortion and
gives you sounds from a slight
overdrive to a powerful distortion.
6SHIFT
The Shift control is a special
designed electronic circuit to select
different colors of overdrive.
7VOLUME (Overdrive)
This control sets the volume level
for the overdrive channel. This only
effects your volume when the
select switch is pushed in.
8BASS
This control allows a total range of
30dB of boost or cut at a frequency
of 120Hz. Due to the high amount
of low frequencies, you may
decrease it at high volumes.
9MID
Set this control to your desired
amountofMIDfrequencies.Incenter
position it is “flat” (No boost or cut).
10 TREBLE
Adjust the high frequencies with
this control to customize your
sound.
11 POWER LED
ThisLED indicator lights upwhenthe
Mean 16 amplifier is switched ON.
12 PHONES
Insert the plug of your headphones
to this jack. The built-in speaker
will be switched off.
13 EXT. SPEAKER (on backside)
For external speakers (4˜8Ω).
Switches the internal speaker off!
14 POWER (on backside)
This switch is used to turn the
Mean 16 amplifier ON.
MASTER EQ
Tone controls Bass,Mid and Treble work for both channels!