DELLA 048-GM-48197 User manual

Wine & Beverage Center
User Manual
Model # 048-GM-48197

1
IMPORTANT SAFEGUARDS
When using this appliance, always exercise basic safety
precautions, including the following:
1) Read all of the instructions before using this appliance.
2) Use this appliance only for its intended purpose as described in this use
and care guide.
3) This wine cooler must be properly installed in accordance with the
installation instructions before it is used. See grounding instructions in the
installation section.
4) Never unplug your wine cooler by pulling on the power cord. Always
grasp the plug firmly and pull straight out from the outlet.
5) Repair or replace immediately, all electric service cords that have become
frayed or otherwise damaged. Do not use a cord that shows cracks or
abrasion damage along its length, the plug or the connector end.
6) Unplug your wine cooler before cleaning or before making any repairs.
Note: If for any reason this product requires service, we strongly
recommend that a certified technician performs the service.
7) If your old wine cooler is not being used, we recommend that you
remove the doors and leave the shelves in place. This will reduce the
possibility of danger to children.
8) This wine cooler should not be recessed or built-in in an enclosed
cabinet. It is designed for freestanding installation only.
9) Do not operate your wine cooler in the presence of explosive fumes.
10) Your wine cooler was NOT designed to store perishable foods.
Store only bottled or canned beverages.
SAVE THESE INSTRUCTIONS
DANGER
Risk of child entrapment. Before you throw away your old
appliance, take off the doors. Leave the shelves in place so
that children may not easily climb inside.

2
Table Of Contents
PAGE
IMPORTANT SAFETY INSTRUCTIONS 1
PARTS AND FEATURES 3
INSTALLING YOUR WINE COOLER 4-5
Unpacking your wine cooler 4
Leveling your wine cooler 4
Proper air circulation 4
Electrical requirements 4
Use of extension cords 4
Installation limitations 5
Door reversal 5
WINE COOLER FEATURES AND USE 6
General features 6
Adjustable temperature dial 6
Wine cooler interior shelves 6
PROPER CARE AND CLEANING 7
Cleaning and maintenance 7
Defrosting 7
Power Interruptions 7
Vacation & moving care 7
Normal operating sounds 8
TROUBLESHOOTING 8
Thank you for choosing this quality
product. This
easy-to-use
manual will
guide
you in getting the
best use
of
your wine cooler.
Remember to record the model and
serial number. They are on a label in
back of the appliance.
Model number
Serial number
Date of purchase
Staple your receipt to your manual.
You will need it to obtain warranty service.

3
WINE COOLER PARTS AND FEATURES
1. Thermostat Dial
(location varies by model)
2. Coated Storage Shelves (style and
quantity vary by model)
3. See-through Glass Door
4. Leveling Legs
5. Recessed Door Handle
6. Lock with Key (Not on all models)
1
1
3
5
6
4
2

4
Installing Your Wine Cooler
Unpacking your Wine Cooler
1. Remove all packaging material. This includes the base and all adhesive tape
holding the wine cooler accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the wine cooler.
Leveling your Wine Cooler
• Your wine cooler has 2 leveling legs, located at the bottom of your wine
cooler. After properly placing your wine cooler in its final position, you can
adjust its level.
• Leveling legs can be adjusted by turning them clockwise to raise the appliance
or by turning them counterclockwise to lower the wine cooler. The door will
close easier when the leveling legs are extended.
Proper Air Circulation
• To ensure that your wine cooler works at its maximum efficiency,
you should install it in a location where there is proper air circulation
and electrical connections.
• The following are recommended clearances around the wine cooler:
Sides……………3/4“ (19 mm)
Top....................2” (50 mm)
Back..................2” (50 mm)
Electrical Requirements
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with
proper grounding to power the wine cooler.
• Avoid the use of three plug adapters or cutting off the third grounding in
order to accommodate a two plug outlet. This is a dangerous practice since it
provides no effective grounding for the wine cooler and may result in
shock hazard. Please note that the use of 2-prong adapters is strictly forbidden
in Canada.
Use of Extension Cords
• Avoid the use of an extension cord because of potential safety hazards under
certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.

Installation Limitations
• Do not install your wine cooler in any location not properly insulated or
heated e.g. garage etc. Your wine cooler was not designed to operate
in temperature settings below 55ºF (12ºC).
• Select a suitable location for the wine cooler on a hard, even surface
away from direct sunlight or heat source, e.g. radiators, baseboard heaters,
cooking appliances etc. Any floor unevenness should be corrected with the
leveling legs located at the bottom.
Door Reversal Instructions
Your wine cooler is built with a reversible door. You have the choice of either
opening it from the left or the right side. In order to reserve the opening direction
of your door, please follow these simple instructions.
Tilt the wine cooler backwards. Secure the rear from sliding. Tape the door to
the cabinet to prevent from falling.
1. Remove the 3 hexagonal screws from base bracket.
2. Remove the pivot holding the bottom of the door.
3. Separate the door from the cabinet and remove the pivot axle from the upper
side of the door. Remove and reinstall upper and lower axle door inserts to
opposite side.
4. Install the pivot axle to the opposite side.
5. Re-attach the door to the cabinet and secure with tape.
6. Attach the base bracket to the opposite side
7. Install the bottom pivot aligning with the lower pivot insert on the door. Attach
the 3 hexagonal screws to base bracket.
8. Remove tape.
9. As the unit was tilted, wait 24 hours before plugging it in.
5

Wine Cooler Features & Use
General Features
Adjustable Temperature Dial:
(located inside the unit, on the right side)
Your wine cooler will automatically maintain the temperature
level you select. The temperature control dial has 3 settings plus
off. MIN is the warmest. MAX is the coldest. Turning the dial to OFF
stops cooling in the wine cooler. At first, set the dial to MED and allow
24 hours to pass before adjusting the temperature to your needs.
(Note: If the wine cooler has been placed in a horizontal or tilted position
for any period of time wait 24 hours before plugging the unit in.)
Wine Cooler Interior Shelves
(Shelves will vary per model purchased)
To remove or replace a full-width slide-out shelf:
1. Gently tilt the shelf up and slide forward until the shelf has been
completely removed.
2. To replace the shelf, gently slide the shelf back.
3. Also features a multi-use can rack. For easy
access to cans.
6

7
Care & Cleaning
Cleaning and Maintenance
Warning: To avoid electric shock, always unplug your wine cooler before
cleaning. Ignoring this warning may result in death or injury.
Caution: Before using cleaning products, always read and follow
manufacturer’s instructions and warnings to avoid personal injury or
product damage.
General: • Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened with
the cleaning solution, to wipe down your wine cooler.
•Rinse with clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. Some
of these chemicals may dissolve, damage and/or discolor your
wine cooler.
Door Gaskets: • Clean door gaskets every three months according to general
instructions. Gaskets must be kept clean and pliable to ensure
a proper seal.
• Petroleum jelly applied lightly on the hinge side of gaskets
will keep the gasket pliable and ensure a good seal.
Defrosting Your Wine Cooler
Your wine cooler is designed with an “Auto-Cycle” defrost system. The wine
cooler surfaces of the unit will defrost automatically, during the “off” cycle of the
cold control. Water
from the unit is disposed of automatically, by means of being
channeled onto a drip tray located on the compressor. Heat transfer from the
compressor causes this water to evaporate.
Power Interruptions
• Occasionally there may be power interruptions due to thunderstorms or other
causes. Remove the power cord from AC outlet when a power outage occurs.
When power has been restored, replug power cord to AC outlet.
Vacation and Moving Care
• For long vacations or absences, empty contents from wine cooler, move the
temperature DIAL to the OFF position and clean the wine cooler, and door
gaskets according to “General cleaning” section. Prop doors open, so air can
circulate inside. When moving, always keep the wine cooler in a vertical
position. Do not move with the unit lying down. Possible damage to the sealed
system could occur.

8
Normal Operating Sounds You May Hear
• Boiling water, gurgling sounds or slight vibrations that are the result of the
refrigerant circulating through the cooling coils.
• The thermostat control will click when it cycles on and off.
Troubleshooting
Wine cooler does not operate
• Check if thermostat control is not in the “OFF” position.
• Check if wine cooler is plugged in.
• Check if there is power at the ac outlet, by checking the circuit breaker.
Temperature appears too warm
• Frequent door openings.
• Allow time for recently added beverages to reach proper temperature.
• Check gaskets for proper seal.
• Adjust temperature control to cooler setting.
Temperature is too cold
• If temperature control setting is too cold, adjust to a warmer setting and allow
several hours for temperature to adjust.
Wine cooler runs too frequently
• This may be normal to maintain constant temperature during high temperature
and humid days.
• Doors may have been opened frequently or for an extended period of time.
• Check gasket for proper seal.
• Check to see if doors are completely closed.
Moisture build up on interior or exterior of the wine cooler
• This is normal during high humidity periods.
• Prolonged or frequent door openings.
• Check door gaskets for proper seal.
Wine cooler door does not shut properly
• Level the wine cooler.
• Check for blockages.