Details Eyesite FPCL User manual

Replacement of an Eyesite Dual
Monitor Mount with a Laptop Mount
Installation Instructions 20467301 Rev A
Tools required:
Eyesite™| Installation Instructions
Page 1 of 4
FPCL
5/32"
HEX DRIVE
#2 Phillips
Screwdriver
Power Drill
5/32" Allen Wrench
(provided)
1/16" Allen Wrench
(not provided)
1
1
Eyesite™
With monitor tilted back 90 degrees, remove all
necessary cables from monitor. Once all cables
are removed from monitor, tilt monitor back to
original position.

2
3
2a
3
MONITOR MOUNT
BRACKET ASSEMBLY
COVER
SET SCREW
2b
MONITOR MOUNT
ASSEMBLY
Page 2 of 4
20467301 Rev A
Open monitor mount bracket
assembly cover (2a).
To release monitor mount, you
must turn set screw to the left
and loosen using a 1/16" Allen
wrench (2b).
Slide monitor mount assembly
from monitor mount bracket
assembly.

4
4a
4c
Page 3 of 4
20467301 Rev A
CAP
PLATE
TRAY
ASSEMBLY
4d
4b
MONITOR
MOUNT
RAIL
ASSSEMBLY
YES NO
End View
NOTE: Push upward on
plate so screws are against
bottom of oblong holes
Remove components as
shown (4a) Remove
existing monitor mount rail
assembly (4b).
Slide tray assembly into rail
(4c).
Re-install plate, screws
and cap (4d). When
installing the screws, insert
screws oblong holes in
plate making sure the
screws are against the
bottom of the oblong holes
instead of the top.
This will ensure that the
rectangular tabs on the
inside of cap will fit properly
into the rail.
PLATE
PLATE

For further information, please go to the Details website details-worktools.com or call 800.833.0411
P.O. Box 1967 / CD-5E Grand Rapids, MI 49501-1967
©2010 Steelcase Inc. All rights reserved. 6/10
Page 4 of 4
20467301 Rev A
5
5
RUBBER MAT
Place rubber mat onto tray and position
accordingly.
Optional Position #1
Optional Position #2
Optional Position #3
SIDE VIEW
LAPTOP MOUNT
RUBBER MAT
Be sure hooks and tabs
are fully engaged.
Use the correct optional position
(#1, #2 or #3) that best aligns the
laptop monitor to & from the user
to minimize eye strain.