DGS Inline User manual

3
1
Included in box
Sign mounting
hardware in
polybag
2
Assemble top to base
Sign can be rotated 90 degrees to base. Rotate sign •
depending on where it will be placed and geng your best
viewing angle.
Use (1) #8 x 1/2” screw. •
Inline Aisle Gondola Sign
assembly instructions
*Note not all hardware may be used during installation.
L Shape
T Shape
ITEM NO. Title QTY.
1 Aisle Sign Base 1
2
Aisle Sign Top 1
3
#8x0.5" P PH SMS 1
4 Sign Mounting Hardware 1
pg. 1 of 3

Retail Gondola Shelving Mount
Set assembled sign in desired locaon on top of •
gondola shelving back panel.
Aach sign to gondola shelving back panel. There are •
two opons to screw the sign in place.
Opon 1 - To screw sign into the pegboard panel use •
(2) #10 x 3/4” wood screws. Screw through the
bracket into the pegboard on both sides of the
gondola.
Opon 2 - To bolt completely through the pegboard •
back panel use (2) 10-24 x 3” nuts and bolts. Line up
bracket holes with pegboard holes and insert bolts
through the pegboard.
Make sure that the sign is level and not angled down. •
Flat Surface or Cooler Top Mount
Bend bracket tab flanges upward. •
Set sign on flat surface. •
Screw sign down using (4) #10 x 3/4” wood screws or •
appropriate fasteners for your applicaon.
Your applicaon may require drilling screw holes into the •
flat surface.
Bend Tab 2x
assembly instructions
pg. 2 of 3
Inline Aisle Gondola Sign

assembly instructions
pg. 3 of 3
Wire Rack Mount
Bend bracket tab flanges upward. •
Set sign onto wire rack or shelf. •
Using the supplied flat metal plate •
aach sign to wire rack using (4) #10
x 3/4” wing nuts and bolts.
Bend Tab 2x
Hang Printed Signs And Adjust Viewing
Height
Hang printed signs to the metal hooks on sign bracket. •
Adjust the sign up or down by pushing in buon and •
extending neck of bracket up or down to the best viewing
posion.
Push button in,
pull up on top
to extend
Inline Aisle Gondola Sign